CYP DS-VWC handleiding
Handleiding
Je bekijkt pagina 21 van 48
21
6.3.5 Customised Video Wall Layouts
The position, size and angle of the display connected to each unit is set
in the Layout window when in Rotation Mode. If you are currently in
the Setting window, clicking on the “Layout” button in the upper-left
“Common” section of the window will switch back to the Layout window
and activate Rotation mode.
The outline of the layout window represents the source video (1920×1080
pixels) and each display must be placed within this space, without
exceeding the edges (not including bezel size, if active). Each display
contains a number which matches the ID number of the unit that is
connected to it and the size/position of each display (listed to the
left) is measured in pixels relative to its size/position within the layout
space. When a bezel measurement is used, the display width/height
measurement should be the total measurement of the screen plus the
bezel.
Note: Video wall configuration and warping is not available in Scaler Mode.
This control software provides a number of common, pre-defined, video
wall configurations, however in most cases a customised layout will be
needed. Custom layouts are created by selecting a layout to use as a basis,
and then right-clicking on the layout’s selection button and selecting
“New” from the dropdown. You then provide a name for the new layout
and click “OK” to generate it. Custom layouts are coloured differently to
make them easy to identify.
Bekijk gratis de handleiding van CYP DS-VWC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | CYP |
| Model | DS-VWC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3951 MB |
