Curtis 1268 handleiding
Handleiding
Je bekijkt pagina 26 van 66
20
Curtis 1268 Manual, Rev. D
THROTTLE 0%
The throttle 0% parameter defines the throttle input voltage at which a throttle
command begins. Voltages lower than the programmed value (but higher than
THRTL FAULT LO) are interpreted to be in a 0% deadband.
THROTTLE 100%
The throttle 100% parameter defines the throttle input voltage that gives a full
throttle command. Input voltages above this value (but lower than
THRTL FAULT
HI) are interpreted as 100% throttle command.
THROTTLE MAP
The throttle map parameter modifies the vehicle’s response to the throttle
input. As shown in Figure 7, this parameter determines the controller output
for a given amount of applied throttle. The
THROTTLE MAP setting refers to the
controller output at half throttle, the midpoint of the throttle’s full active range
(the range between
THROTTLE 0% and THROTTLE 100%).
3 — PROGRAMMABLE PARAMETERS: Throttle Parameters
Throttle Parameters
Fig. 7 Throttle maps for
controller with the Throttle
Map parameter set at vari
-
ous values.
Setting THROTTLE MAP at 50% provides a linear output response to throttle
position. Values below 50% reduce the controller output at low throttle settings,
providing enhanced slow speed control. Values above 50% give the vehicle a
faster, jumpier feel at low throttle settings.
Controller output begins when the throttle is moved beyond
THROTTLE 0%,
and continues to increase—following the curve defined by the
THROTTLE MAP
setting—as the throttle input increases, and reaches maximum output when
the throttle input crosses the
THROTTLE 100% threshold.
Bekijk gratis de handleiding van Curtis 1268, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Curtis |
| Model | 1268 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7778 MB |
