Curtis 1212 handleiding
Handleiding
Je bekijkt pagina 15 van 47
2 — INSTALLATION AND WIRING
pg. 11
Return to TOC 1212 Manual – Sept. 2022
Status LED
e controller has the capability to drive a panel indicator LED, which can be used to tell the operator,
at a glance, the controller’s status. is LED always indicates whether the controller is powered on or
o. It will also provide diagnostics information via ash codes (see Chapter 7).
If a status LED is used, it should be installed with the proper resistor in series. e controller’s LED
driver is capable of a maximum current of 15 mA. e recommended resistor—designed to limit
driver current to 15 mA when active—is 2.4 kΩ, 0.5 W. Alternatively, an LED with a built-in resistor
can be used; it should be rated for 24V operation.
Horn
e controller’s horn driver—Pin 3—is designed to drive a low current DC horn at 1 Hz. e horn
sounds a warning when the reverse direction is selected and when the throttle autocalibration feature
is being used. e horn driver sinks a maximum current of 15 mA. Using a horn with a higher current
requirement will damage and disable the driver. e horn driver can be used to drive a brake light
instead of a horn; see Brake menu.
Reverse Switch
If a single-ended or unipolar throttle is used, a reverse switch connected to Pin 12 can be used to
change the driving direction to reverse.
Bekijk gratis de handleiding van Curtis 1212, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Curtis |
| Model | 1212 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5028 MB |
