Crystal Video BeamLink-Ultimate handleiding
Handleiding
Je bekijkt pagina 16 van 19
26
27
Mode:STA
WiFi IP:192.168.1.201
Encoder IP:192.168.1.111
Wireless Transmission Module Upgrading
1. The transmitter operates the same as the wireless software upgrade
of the receiver.
2. The back of each device’s body will be labeled with the IP address of
WiFi and the IP address of the encoder/decoder. The default IP
addresses are as follows:
(Take the following figure as an example: The device’s operating mode,
WiFi IP(wireless transmission module IP), and IP of the Encoder/Decoder
can be found.)
First, connect the computer to the LAN port of the receiver;
Then enter the device’s WiFi IP (wireless transmission module IP) in the
address bar to enter the login page:
After successful login, enter the WiFi board parameter page of the device:
Enter username: admin
Enter password: admin
192.168.1.201, 192.168.1.202, 192.168.1.203, 192.168.1.204
Encoder IP
192.168.1.111, 192.168.1.112, 192.168.1.113, 192.168.1.114
192.168.1.100
Receiver
192.168.1.211，192.168.1.212，192.168.1.213，192.168.1.214
Transmitter
Wireless
transmission
module IP
(WiFi IP)
Decoder IP
Wireless
transmission
module IP
(WiFi IP)
Each transmitter has one wireless transmission module, and the software
upgrading needs to be implemented on each transmitter. Receiver also has
one wireless transmission module, and the software upgrading needs to be
implemented on it accordingly.
Information label on transmitter:
Bekijk gratis de handleiding van Crystal Video BeamLink-Ultimate, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Crystal Video |
| Model | BeamLink-Ultimate |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3546 MB |
