Handleiding
Je bekijkt pagina 20 van 80
20 49-1000107 Rev. 5
Installation Instructions
INSTALLING THE REFRIGERATOR
INSTALLATION INSTRUCTIONS
SLIDE-ON TYPE FREEZER
HANDLE
Install the freezer handle to the mounting fasteners by
aligning the slots inside the handle endcap with the
mounting fasteners. Being careful to avoid scratching
the door finish, slide the handle to the right until it comes
to a hard stop.
Use a rubber mallet (if unavailable, a hammer with a
towel wrapped around head of hammer can be used as
well), to gently tap the left side of handle until the handle
no longer moves left or right. A few taps should be
used rather than using heavy force witch can cause
handle/endcaps to get damaged.
2A
Fasteners
Slot
Endcap
Freezer Handle
2B
FREEZER HANDLE WITH
SET-SCREWS
Ŷ IMPORTANT: Do not use power tools to
tighten set screws.
Tools Provided:
Ŷ´KH[NH\
+DQGOHDSSHDUDQFHPD\YDU\EDVHGRQPRGHO
however, the installation process is the same.
Remove any protective film from the door
or drawer fronts before installing handles (if
applicable).
Remove handle from packaging and locate
WKHSURYLGHG´KH[NH\
Place the handle over the mounting fasteners
until it is flush against the surface of the door.
Tighten both set screws in the handle end
FDSVE\WXUQLQJWKH´KH[NH\FORFNZLVH
until the handle will not hang loose or fall
from its mounting. Do not fully tighten yet.
IMPORTANT: Hold the handle firmly against
the door, make sure there are no gaps
between the handle end caps and the door,
and fully tighten the set screws.
To remove, reverse the installation process.
A
B
C
D
E
F
Bekijk gratis de handleiding van Crosley XNE25JGKW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Crosley |
| Model | XNE25JGKW |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 7474 MB |
