Crosley CWW4512RW handleiding
Handleiding
Je bekijkt pagina 5 van 24
5
Adjustable pliers that
open to 1¾" (45 mm)
Flashlight
Bucket
Parts Supplied:
NOTE: All parts supplied for installations are in the washer.
Drain hose with clamp, U-form,
and cable tie
Parts Needed: (if not supplied with washer)
Inlet hoses with flat washers
NOTE: Various inlet hose
options are available; check
your Quick Start Guide for
ordering information.
Alternate Parts: (not supplied with washer)
Your installation may require additional parts. To order, please
refer to the contact information referenced in your Quick Start
Guide.
If you have:
You will need:
Overhead sewer Standard 20 gallons (76 L) 39" (990
mm) tall drain tub or utility sink, sump
pump, and connectors (available from
local plumbing suppliers)
1" (25 mm) standpipe 2" (51 mm) diameter to 1" (25 mm)
diameter standpipe adapter and
connector kit
Drain hose too short Extension drain hose and connector kit
Lint-clogged drain Drain protector and connector kit
Location Requirements
Select proper location for your washer to improve performance
and minimize noise and possible “washer walk.” Install your
washer in a basement, laundry room, closet, or recessed area.
IMPORTANT: Do not install, store, or operate washer where it will
be exposed to weather or in temperatures below 32°F (0°C).
Water remaining in washer after use may cause damage in low
temperatures. See “Washer Maintenance and Care” for
winterizing information.
Proper installation is your responsibility.
You will need:
� A water heater set to 120°F (49°C).
� A grounded electrical outlet located within 4 ft (1.2 m) of power
cord on back of washer.
� Hot and cold water faucets located within 3 ft (0.9 m) of hot
and cold water fill valves on washer, and water pressure of
20-100 psi (138-690 kPa).
� A level floor with maximum slope of 1" (25 mm) under entire
washer. Installing on carpet or surfaces with foam backing is
not recommended.
� Floor must support washer’s total weight (with water and load)
of 315 lbs (143 kgs).
Recessed area or closet installation
3"
(76 mm)
3"
(76 mm)
24 in
2
(155 cm
2
)
48 in
2
(310 cm
2
)
19"/22"
1"
1"
(25 mm)
(25 mm)
5"
(126 mm)
14"
(356 mm)
maximum
(482/559 mm)
NOTE: All 27" wide washers should have 19" (482 mm)
clearance, while all 29" wide washers should have 22" (559 mm)
clearance.
All dimensions show recommended spacing allowed, except for
closet door ventilation openings, which are the minimum required.
This washer has been tested for installation with spacing of 0"
(0 mm) clearance on the sides. Consider allowing more space for
ease of installation and servicing, and spacing for companion
appliances and clearances for walls, doors, and floor moldings.
Add spacing of 1" (25 mm) on all sides of washer to reduce noise
transfer. Doors must be louvered or equivalent and have at least
24 in
2
(155 cm
2
) bottom and 48 in
2
(210 cm
2
) top open area.
*For additional details (or information) specific to your model, refer
to your Quick Start Guide.
Bekijk gratis de handleiding van Crosley CWW4512RW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Crosley |
| Model | CWW4512RW |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 2012 MB |
