Handleiding
Je bekijkt pagina 13 van 40
13
1. Part of metal Ground-link strap must be cut out and removed.
A
B
A. Ground-link strap
B. Ground-link screw
2. Use a Phillips screwdriver to remove the ground-link screw
from the back of the range. Save the ground-link screw and
the end of the Ground-link strap under the screw.
3. Feed the power supply cord through the strain relief on the
cord/conduit plate on bottom of range. Allow enough slack to
easily attach the wiring to the terminal block.
A
B
D
C
E
A. Terminal block
B. Ground-link
screw
C. UL listed strain
relief
D. Power supply cord wires
E. Ground-link strap end piece
4. Use Phillips screwdriver to connect the green ground wire
from the power supply cord to the range with the ground-link
screw. Insert the ground-link screw through the ground-link
strap end piece and the green ground wire. The ground wire
must be attached first.
5. Use 3/8" (9.5 mm) nut driver to connect the neutral (white)
wire to the center terminal block post with one of the 10-32
hex nuts.
A
B
C
G
E
F
D
A. 10-32 hex nut
B. Ground-link
screw
C. Line 2 (red)
D. Green ground
wire
E. Neutral (center) wire
F. Line 1 (black)
G. Ground-link strap end piece
6. Connect line 2 (red) and line 1 (black) wires to the outer
terminal block posts with 10-32 hex nuts.
7. Using a torque wrench, tighten the hex nuts to a
recommended torque of 20 in-lbs (2.3 N-m).
NOTE: For power supply cord replacement, use only a power
cord rated at 250 V minimum, 40 A or 50 A that is marked for
use with nominal 1
3
⁄
8
" (3.5 cm) diameter connection opening,
with ring terminals and marked for use with ranges.
8. Tighten strain relief screws.
IMPORTANT: Verify the tightness of the hex nuts.
9. Replace terminal block access cover.
10. Reconnect power.
3-Wire Connection: Power Supply Cord
Use this method only if local codes permit connecting chassis
ground conductor to neutral wire of power supply cord.
1. Feed the power supply cord through the strain relief in the
cord/conduit plate on bottom of range. Allow enough slack to
easily attach the wiring to the terminal block.
A
B
D
C
A. Terminal block
B. Ground-link
screw
C. UL listed strain relief
D. Power supply cord
wires-large opening
Bekijk gratis de handleiding van Crosley CREW3874RB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Crosley |
| Model | CREW3874RB |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3650 MB |
