Crestron CLTIBN-1DIM4 handleiding
Handleiding
Je bekijkt pagina 3 van 12
Crestron CLTIBN Terminal Block with Breaker
Module Installation
5. Refer to the respective CLTI/CLXI Installation
Guide for instructions on completing the
installation and testing of the CLXI module.
CAUTION: CLXI modules contain electrostatic
sensitive devices (ESDs); units must be handled from
metal chassis – do not touch PC boards or components.
Access Door Installation
After the terminal block and module have been installed
and successfully tested, the access door must be installed
on the CAENIB’s cover in the location of the terminal
block.
NOTE: CLXI modules are to be installed after the
enclosure has been completely wired and load wiring has
been verified. Refer to the terminal block installation
procedure on the previous page for details.
1. If a blank plate is installed, remove it by
removing the nuts that secure the plate to the
CAENIB cover. Remove the plate from the
mounting studs on the CAENIB cover.
1. Use the four supplied self-tapping screws (8B x
¼ (6 mm) length) to secure the module to the
enclosure.
2. Connect the CLXI modules to their
corresponding CLTIBN terminal blocks as
shown in the terminal block-to-module wiring
diagrams that start on page
4. Illustrations are
provided for installation on the right and left
sides of a CAENIB enclosure. Wires are pre-
stripped to 12 mm. Tighten terminal blocks to
1 Nm. Tighten circuit breaker lugs to 1.2 Nm.
2. Install the access door assembly as shown in the
following diagram.
Install Access Door Assembly (Underside of CAENIB Cover
shown)
NOTE: Do not remove any factory-installed jumper
wires or bus-bars.
3. Replace the cover plate that was removed during
the terminal block installation procedure
described on the previous page.
4. If the module is being installed above or below
another module within the enclosure, attach the
supplied module interconnect cable between the
two modules. The following illustration depicts
the area within a double-wide enclosure where
the corners of four modules meet.
NOTE: One wire on the module interconnect cable
may be a different color from the rest. The color has
no bearing on its orientation during installation.
3. Secure the door assembly to the CAENIB cover,
by tightening the included nuts.
4. Open the access door and affix the included
blank circuit label to the door. Label the circuits
as required.
Use Module Interconnect Cable to Wire Module to Module
MODULE
INTERCONNECT
CABLE ATTACHED
CONNECTION
NOT
MADE
Installation Guide – DOC. 6561A Terminal Block: CLTIBN • 3
Bekijk gratis de handleiding van Crestron CLTIBN-1DIM4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Crestron |
| Model | CLTIBN-1DIM4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2218 MB |
