Crest Audio CPL 8+ handleiding
Handleiding
Je bekijkt pagina 12 van 16

10
e compact loudspeaker shall consist of a 8 inch (200 mm) low frequency transducer with 2 inch (50 mm) voice
coil and a 1 inch (25.4 mm) exit compression driver with a 1.3 inch (34 mm) voice coil and a frequency dividing
network installed within the enclosure.
Performance specications of a typical production unit shall be: Measured sensitivity SPL at 1 m (3.3) with
2.83V input, shall be 95 dB-SPL. Usable frequency response shall extend from 67 Hz to 20 kHz (10 dB below rated
sensitivity, in full space, with no external equalization). Nominal impedance shall be 8 Ohms. Rated power
capacity shall be at least 200 Watts continuous power and 800 Watts peak power, dened as 6 dB above a test signal
of ltered random noise.
e system shall be protected against damage from occasional over-powering limiting the power to the network
and transducers. e compression driver shall be capable of even coverage at a nominal 60° horizontal through
60° vertical distributed pattern.
e enclosure shall be constructed from prime-grade 15 mm plywood. e loudspeaker shall be equipped with a
total of thirteen (13) suspension points. e grille shall be of heavy-duty steel backed with acoustically transparent
foam. e external wiring shall be via either two 4-pin twist-lock or one 4-pin Euroblock connectors. e
loudspeaker shall be 16.54 inches (420 mm) high by 10.59 inches (269 mm) wide by 10.83 inches (275 mm) deep
weighing 24.6 pounds (11.2 kg). e nish shall be a paintable lightly textured black or white.
e compact loudspeaker shall be the Crest Audio CPL 8
+
.
ARCHITECT'S & ENGINEER'S SPECIFICATIONSEN
Bekijk gratis de handleiding van Crest Audio CPL 8+, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Crest Audio |
| Model | CPL 8+ |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 2049 MB |



