Handleiding
Je bekijkt pagina 4 van 13
5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Convection
Humidity Oven
FL-2373
Rev. 2 (9/14)
Page 4 of 13
OPERATING INSTRUCTIONS
HOW TO USE THE ROAST-N-HOLD CONTROL:
*Push the lighted switch on the control panel; the light
will come on and the cabinet will start heating.
*The display will read “LOTPR” (low temperature)
below 140°F. (60°C.).
NOTE: Wait one (1) hour after start up before loading the
food for best results.
The display will read “PREHT” until the cabinet
reaches the set temperature.
Cooking:
1. Press the COOK button.
2. Turn the control knob to the desired cooking
temperature between 200°F (93°C) and 350°F (176°C).
3. Push the knob to set the temperature.
4. The control automatically goes to the HOLD mode.
(Continue to HOLDING step 1 next column ).
Setting the time or Food Probe:
1. If NOT using the Food Probe:
a) Turn the control knob to the desired hours/minutes.
b) Push the knob to set the time.
2. Using the Food Probe:
Plug in the food probe BEFORE you enter the TIME
mode. Otherwise, you have to press the PROBE
button to set the probe temperature.
a) Turn the knob to the desired temperature.
b) The timer will stop when the probe reaches the set
temperature.
3. Press the START button. The display will show
“READY” when preheated.
4. Press the START again to use this recipe (see Recipes”).
Note: Press the knob for 4 seconds to cancel the recipe.
The DISPLAY button shows (cycles through) all the
values when in each mode:
• “PREHEAT” OR “READY”: momentarily shows the
actual cabinet temperature.
• “COOK” (Timed): shows Home screen, set point,
count down time, actual cabinet temperature.
• “COOK” (Probe): shows Home screen, set point,
count up time, actual cabinet temperature.
• “HOLD”: shows Home screen, set point, count up
time, actual cabinet temperature.
FIRST-TIME OPERATION
NOTE: A new oven needs to “burn off” manufacturing
oils and excessive adhesive before its rst use.
Do NOT load food into oven until this has been
done!
1. Push the switch to on; the light will come on.
NOTE: The letters “LOTPR” (low temperature) will show
on the control panel until it reaches 140°F (60°C).
2. Press the “COOK” button.
3. Push down and turn the control knob to show 200°F.
Push the knob again to set the temperature. Run the
unit for one (1) hour.
4. Turn the unit off and let cool.
5. Wipe the inside clean with detergent and hot water.
Holding:
(Press the HOLD button only if you are just holding food),
1. Turn the control knob to the desired holding
temperature between 140° (60°C) and 220°F (104°C).
2. Push the knob to set the temperature.
3. The control automatically goes to the TIME mode.
Bekijk gratis de handleiding van Cres Cor CO151XWUA5DE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cres Cor |
| Model | CO151XWUA5DE |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 4134 MB |
