Handleiding
Je bekijkt pagina 12 van 32
12
USER
MANUAL
Installation Under Counter
Cabinet shall conform with dimensions specified in fig. 2.
A clearance with the dimensions specified in the figure shall be ensured at the rear compartment of the cabinet to
provide the required ventilation.
After installation, the clearance that shall be left between the bottom of the counter and the top of the appliance is
indicated by “A” in fig. 5. This is for ventilation and it shall not be closed.
Installation In A High Cabinet
The cabinet shall comply with the dimensions given in fig. 4.
In the rear part of the cabin, and at the top and bottom, clearances with the dimensions specified in the figure shall
be ensured to provide the required ventilation.
Installation Conditions
The dimensions of the appliance are given in figure 3.
The furniture surfaces to be installed and the installation materials to be used shall resist a temperature of at least
100 °C.
To prevent the appliance from turning over, the cabinet to be installed shall be fixed and the cabinet floor shall be
level.
The floor of the cabinet shall be strong enough to withstand a load of at least 60 kg.
Placing and Securing Of The Oven
Place the oven to the cabinet with two or more persons.
Make sure that the frame of the oven and the front of the furniture are properly aligned.
The supply cord shall not be left under the oven or be stuck or bent between the oven and the furniture.
Secure the oven to the furniture using the screws supplied with the appliance. Screws shall be installed by putting
them through the plastics attached on the frame of the appliance as shown in figure 5. The screws shall not be
tightened too much. Otherwise, the screw holes may wear out.
Check that the oven does not move after installation. If the oven has not been installed in accordance with the
installation instructions, there is a risk of overturning during operation.
Electrical Connection
The place where the product shall be installed shall have proper electrical installation.
The mains voltage shall comply with the rating given on the product type plate.
Connection of appliance shall be made in accordance with local and national electrical regulations.
Disconnect the mains power before starting to install the product. Do not connect the product to the mains until the
installation is finished.
Bekijk gratis de handleiding van Creda C80BISMFX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Creda |
| Model | C80BISMFX |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 3257 MB |
