Handleiding
Je bekijkt pagina 9 van 24
9
USER
MANUAL
Transformation from natural gas to LPG and from LPG to natural gas
1. Turn off gas and electricity of the hob. If your hob is hot, wait for cooling down.
2. For injector change, use a screwdriver whose edge is as the figure 1.
3. As seen in figure 2, demount burner lid and burner of the hob and ensure visibility of injector.
4. Remove injector by turning as shown in figure 3 with screwdriver and replace it with a new one.
5. After that, detach control switches of the hob. Make setting by turning the screw in the middle of gas cocks with
a small screwdriver in the manner shown in the following picture. To adjust flow rate screw, use a screwdriver
having suitable dimension. For LPG, turn the screw clockwise. For natural gas, turn the screw one time counter
clockwise. At low position, length of normal flame should be 6-7 mm. For the last control, check out whether
flame is open or closed.
Setting of your appliance may differ according to the type of gas cock used.
Ventilation Of Room
The air needed for burning is received from room air and the gases emitted are given directly in room. For safe
operation of your product, good room ventilation is a precondition. If no window or room to be utilized for room
ventilation is available, additional ventilation should be installed. However, room has a door opening outside, it is
no needed to vent holes.
Room size
Ventilating opening
Smaller than 5 m³
min. 100 cm²
Between 5 m³ - 10 m³
min. 50 cm²
Bigger than 10 m³
no need
In basement or cellar
min. 65 cm²
Bekijk gratis de handleiding van Creda C60GFCWG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Creda |
| Model | C60GFCWG |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3331 MB |
