Handleiding
Je bekijkt pagina 6 van 36
INSTRUCTION
MANUAL
6
Electrical Safety
1. Have an authorized electrician set grounding equipment. Our company shall not be responsible for the damages
that shall be incurred due to using the product without grounding according to local regulations.
2. The circuit breaker switches of the oven shall be placed so that end user can reach them when the oven is
installed.
3. The power supply cord shall not contact the hot parts of the appliance.
4. If the power supply cord is damaged, this cord shall be replaced by the manufacturer or its service agent or an
equally qualified personnel to prevent a hazardous situation.
5. Never wash the product by spraying or pouring water on it! There is a risk of electrocution.
6. WARNING: To avoid electric shock, ensure that the device circuit is open before changing the lamp.
7. WARNING: Cut off all supply circuit connections before accessing the terminals.
8. WARNING: If the surface is cracked, turn off the appliance to avoid risk of electric shock.
9. Do not use cut or damaged cords or extension cords other than the original cord.
10. The rear surface of the oven also heats up when the oven is operated. Electrical connections shall not touch the
rear surface, otherwise the connections may be damaged.
11. Do not tighten the connecting cables to the oven door and do not run them over hot surfaces. If the cord melts,
this may cause the oven to short circuit and even a fire.
12. If the power supply cable is damaged, it must be replaced by its manufacturer or authorized technical service or
any other personnel qualified at the same level, in order to avoid any dangerous situation.
13. Do not use steam cleaners for cleaning the appliance, otherwise electric shock may occur.
14. An omnipolar switch capable to disconnect power supply is required for installation. Disconnection from power
supply shall be provided with a switch or an integrated fuse installed on fixed power supply according to building
code.
15. Appliance is equipped with a type ‘’Y’’ cord cable.
16. Fixed connections shall be connected to a power supply enabling omnipolar disconnection. For appliances with
over voltage category below III, disconnection device shall be connected to fixed power supply according to
wiring code.
Bekijk gratis de handleiding van Creda C60CTC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Creda |
| Model | C60CTC |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3207 MB |
