Handleiding
Je bekijkt pagina 10 van 32
10
USER
MANUAL
Right Place For Installation
Product has been designed to be mounted to worktops procured from market. A safe distance must be left between
the product and kitchen walls or furniture. See the drawing provided on the next page for proper distances. (values
in mm).
• Used surfaces, synthetic laminates and adhesives must be heat resistant. (minimum 100 °C)
• Kitchen cupboards must be level with product and secured.
• If there is a drawer below the oven, a rack must be placed between oven and drawer.
WARNING: Do not install the product next to refrigerators or coolers. The heat emitted by the product increases
the energy consumption of cooling devices.
WARNING: Do not use door and/or handle to carry or move the product.
60 cm Built-In Oven Installation And Mounting
Place of use for product must be located before starting installation.
Product mustn't be installed in places which are under the effect of strong air flow.
Carry the product with minimum two people. Do not drag the product so that floor isn't damaged.
Remove all transportation materials inside and outside the product. Remove all materials and documents in the
product.
Installation Under Counter
Cabin must match the dimensions provided in figure 2.
A clearance must be provided at the rear part of the cabin as indicated in the figure so that necessary ventilation
can be achieved.
After mounting, the clearance between lower and upper part of the counter is indicated in figure 5 with "A". It's for
ventilation and shouldn't be covered.
Installation In An Elevated Cabinet
Cabin must match the dimensions provided in figure 4.
The clearances with the dimensions indicated in the figure must be provided at the rear part of cabin, upper and
lower sections so that necessary ventilation can be achieved.
Installation Requirements
Product dimensions are provided in the figure 3.
Furniture surfaces for mounting and mounting materials to be used must have a minimum temperature resistance
of 100 °C.
Mounting cabin must be secured and its floor must be plane for product not to tilt over.
Cabin floor must have a minimum strength that would handle a load of 60 kg.
Bekijk gratis de handleiding van Creda C60BIMFX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Creda |
| Model | C60BIMFX |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 3840 MB |
