Cooking Performance Group 351CPGSP18N handleiding

Fornuis

Cooking Performance Group

10 pagina's

PDF beschikbaar

Handleiding

www.cookingperformancegroup.com

User Manual

INSTALLATION

NOTE: This installation is to be carried out by a certied technician. Issues related to installation, such as

adjustments and calibrations, are the responsibility of the installer and are not matters of warranty. Proof

of installation may be required to make a warranty claim.

WARNING: Before installation, please read instructions completely and carefully. Do not remove

permanently afxed labels, warnings, or plates from the product.

1. Carefully unbox the unit and remove all packaging and protective plastic lms.

2. Choose a location for the unit with the proper ventilation (see Exhaust System below) and with the

proper gas connection (see Gas Connection below).

3. Please note the required clearances listed in the specications table on pg. 4.

4. A manual gas shut-off valve must be installed in the gas supply line ahead of the appliance and gas

pressure regulator for safety and ease in servicing.

5. Check all gas connections for gas leaks using only soapy water. Never use an open ame to check

gas connection.

Start Up

1. The serial plate is located on the side of the unit. It

indicates the type of gas the unit is equipped to use. All

Equipment is set for use with the specied gas type at

the factory.

2. The equipment is design-certied for operation on either

natural or propane gas; it should only be connected to

the type of gas for which it is equipped as stated on the

serial plate.

3. A 3/4” NPT inlet is located at the rear for the gas connection. The external regulator provided with

the unit must be installed. An adequate gas supply is imperative. Undersized or low pressure lines

will restrict the volume of gas required for satisfactory performance. Failure to install the supplied

regulator will void the unit warranty.

4. Ensure the supply line is clean before connecting the line to the unit.

5. A manual gas shut-off valve must be installed in the gas supply line ahead of the appliance and

gas pressure regulator for safety and ease in servicing.

6. All pipe joints and connections must be tested thoroughly for gas leaks. Use only soapy water for

testing on all gases. Never use an open ame to check for gas leaks.

Gas Connection

Bekijk gratis de handleiding van Cooking Performance Group 351CPGSP18N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.