Collomix AQiX handleiding

Handleiding

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172/ 72

Afdrukken

Je bekijkt pagina 10 van 72

Care and maintenance

Clean equipment: Keep the instrument clean and remove any dirt immediately.

Clean the instrument with a damp cloth and a mild cleaning detergent (soap). Do not use

any cleaning agents containing solvents.

Changing the baeries: To change the baeries, open the baery compartment (3) cover using a screwdriver.

Remove the old baeries. Insert the new baeries (AA) in the baery compartment ac-

cording to the labelling. Remove the rubber seal from the cover and clean it. Do not dam-

age the seal. We recommend lubricang the seal with silicone grease.

Reinsert the rubber seal into the groove of the cover, ensuring the seal ts exactly.

Before screwing the cover back on, make sure that the rubber seal is not crushed. You can

tell that a seal is not properly seated as the gap in the cover is not parallel.

Place the cover so that it is level and screw it back into place with the 3 screws.

If the seals are not inserted correctly, this may impair the leak-ghtness of the instrument.

Do not reuse damaged seals.

Replacing the hose

connecon:

Loosen by turning counter-clockwise

Place the new hose coupling with seal on the thread and ghten in the clockwise direcon.

Cleaning the screen: There is a parculate screen in the water supply (5) that holds back larger parcles in the

supply water. It is recommended to clean the screen from me to me.

Unscrew the hose connecon as described above.

Use pliers to grab the screen at the protruding screen clip and pull it out.

Clean the screen under owing water and re-insert it.

Screw the hose connecon back on.

Back-ushing: There is also a screen before the water outlet (7). If the amount of water decreases signif-

icantly, this needs to be cleaned. The hose must be connected to the water outlet only for

this reason and this reason only. At the same me, the second screen at the water supply

(5) must be removed (see above). Then ush the instrument backwards to remove the

deposits. Then disconnect the hose and re-insert the screen at the water supply.

Water lter: The use of a pre-lter is recommended to supply the AQiX with water.

(mesh size 0.08 - 0.1 mm)

Nocaon in the display Descripon Reccaon

BAT nocaon in the display area

visualizes that the baery is empty

Change the baeries

Display of a circumferenal line

visualizes that there is no water in

the instrument

• Ensure a water supply to the instrument

• Check whether the instrument inlet is dirty

and remove any dirt if necessary

No nocaon in display aer

pressing the "START/PAUSE” buon

• Change the baeries

• If there is sll no nocaon aer changing

the baeries, then send in the instrument for

repair

Faults - Troubleshoong

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172/ 72

Bekijk gratis de handleiding van Collomix AQiX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Gerelateerde producten van Collomix (Niet gecategoriseerd)

Handleiding bekijken

Collomix TMX 1500

Niet gecategoriseerd - handleiding

Andere merken in Niet gecategoriseerd