Cleco A8R336M handleiding
Handleiding
Je bekijkt pagina 4 van 14
Page 4
PL70-A8-EN
03/03/2017
General Safety Instructions
These Safety Instructions are not intended to be all
inclusive. The operator should also study and comply with
all applicable Federal, State, and Local Regulations.
Designated Use
This pneumatic motor is to be used exclusively as a power
source and integrated into an application or machine.
Do not modify the motor, any guard, or accessory
unlessapprovedinwritingbyApexToolGroup,
LLC. All safety devices must be properly installed
and maintained in good working order.
Putting into service
Onlyfullytrainedpersonnelshouldinstall,adjust,operate,
or repair this equipment.
Personal protective equipment
Exercise caution, pay attention to what
you are doing and act reasonably at all
times when working with a pneumatic tool.
Never use a pneumatic tool while under the
inuence of drugs, alcohol or medication.
Onemoment of inattentiveness inthe use of
a pneumatic tool can cause serious injuries.
Risk of injury by being wound up in and caught by machinery:
When working with rotating parts, it is
prohibited to wear gloves.
→Wearclosettingclothing.
→Ifnecessary,wearahairnet.
Risk of injury due to ejected components:
Wear protective goggles.
Air supply
Connect the tool to a clean lubricated air supply capable
of providing a measured maximum air supply of 90 psig at
the tool with the tool running and the lever fully depressed.
Make certain an air shut off valve is installed within reach of
the motor’s workspace.
Air Line Lubrication:
UseApexToolGroup,LLCorApexToolGroupGmbH&Co.
OHG’s lightweight air tool oil 500021 (available in quantities
showninthefollowingchart)oranSAE-5lightweightspindleoil.
Recommended Grease:
“DO NOT SUBSTITUTE LUBRICANTS”
The proper grades of oil and grease are essential for the
efcient operation of these air motors. Heavy oil will not
ow through a lubricator at a satisfactory rate to insure
properlubricationofthemotor.Greasesthataretoostiffwill
channel and fail to lubricate properly and greases that are
too thin will blow out of the motor. Improper lubrication or
inadequate lubricants can cause extensive motor damage.
Greasettingsarelocatedonthemotorhousingandgear
housing for each stage of gearing. The following quantities
ofA123771(HighTemp540450)greaseareprovidedduring
factory assembly and these same amounts must be provided
whenever the air motor is disassembled.
• Motorassembly:12oz.
• Gearingassembly(each):4oz.
During normal operation, the motor wil loose a small amount
of grease through the exhaust making it necessary to add
greaseatregularintervals.Aftereach50hoursofoperation
add2.0oz.ofA123771(HighTemp540450)greasetothe
motor housing.
Excessive grease in the motor housing will
cause a loss of motor performance. Not
enough grease will cause premature motor
failure.
Too much grease in the gear case will force
the seal out of the front housing.
The gear case will lose grease through the motor. The
motor will siphon gear grease, saturated with airline oil,
throughtheexhaust.After200hoursofoperation,add1.0
oz.ofA123771(HighTemp540450)greaseintoeachgear
housing
Service and Repair:
Toolserviceandrepairshouldbeperformedbyanauthorized
ApexToolGroup,LLCorApexToolGroupGmbHService
Center. Refer to the last page of this manual for locations.
Only qualied and trained personnel are to repair this
equipment.
Replace worn or damaged parts using only genuine brand
replacement parts manufactured or supplied by Apex Tool
Group,LLC.
Immediately shut off the tool and disconnect the air supply
ifyounoticeunusualsoundorexcessivevibration.Havea
qualiedrepairtechnicianinspectthetoolandrepairbefore
placing it back into operation.
Parameter Description
Air Hose
Minimum inside diameter:
1/2" (12.7mm)
Maximum length: 16.4' (5 m)
Working
pressure range
Performance rated at: 90 psi (620 kPa)
Compressed air
Air quality according to ISO 8573-1, quality
class 2.4.3
The compressed air must be clean and dry.
Part No. Packaged Designation
540397 1 Quart (0.94 liter) Airlube 10W/NR-420LB DR
533485 1 US Gallon (3.78 liter) Airlube 10W/NR-420LB DR
Part No. Packaged Designation
A123771 16 oz. (0.45 kg) Shell Alvania® EP 00
540450 16 oz. (0.45 kg) Chevron Black Pearl® EP NLGI
Product Information
Bekijk gratis de handleiding van Cleco A8R336M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cleco |
| Model | A8R336M |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3254 MB |
