Cleanmaxx 15176 handleiding
Handleiding
Je bekijkt pagina 13 van 16
Dust mite vacuum cleaner
EN
13
NOTICE – Risk of Damage to
Material and Property
■ Only connect the device to a plug socket
that matches the technical data of the
device.
■ Only use suitable extension cables
whose technical data is the same as that
of the device.
■ Do not try to lubricate the rollers with
lubricant or oil. This would cause dust
and dirt to increasingly adhere to the
rollers.
■ Use only original accessories from the
manufacturer in order to guarantee that
there is no interference that may prevent
the device from working and to avoid
possible damage.
■ Use only the UV-C lamp type specified
in the “Technical data” chapter.
SAFETY DEVICES
The device has two safety switches(11, 14).
The UV-C lamp(9) only switches on if both
safety switches are pressed into the motor
unit(3) (automatic switch-off function of
the UV-C lamp deactivated). This happens
automatically when the device is placed
on a flat surface. If the safety switches
lose contact with the surface below, the
automatic switch-off function is activated
and the UV-C lamp stops being lit (auto-
matic switch-off function of the UV-C lamp
activated).
USE
Please Note!
■ The device should only be used if it has
been fully and correctly assembled! The
dust container and the filter must be
inserted and must not be damaged!
If the dirt were to get inside the motor
unit, this could damage the motor.
■ Make sure that the safety switches of
the UV-C lamp are not blocked!
1. Place the device down flat on the surface
which is to be cleaned.
2. Switch on: Press the On / Off switch(2).
The device starts to vacuum and the
UV-C lamp (9) and the vibration head
(12) switches on.
L
The vibration shakes up the surface
which is to be cleaned and the
dust which is agitated is sucked in
through the suction opening (13).
3. Guide the device very slowly and evenly
over the surface to be cleaned.
4. Switch off: Press the On / Off switch
again.
CLEANING THE DEVICE
Please Note!
■ Empty the dust container after each use.
Also clean the filter regularly to prevent
overloading of the motor.
■ Do not use any sharp or abrasive
cleaning agents to clean the device
and accessories. They may damage the
surfaces.
■ The UV-C lamp will become hot during
use. Allow the UV-C lamp to cool su-
ciently before cleaning the device. There
is adanger of burns!
L
The filter(5) should be replaced
every 12 – 18months; the UV-C
lamp(9) should be replaced every
12 – 24months.
• Make sure the device is disconnected
from the power supply and has cooled
down.
• Motor unit(3): As required, wipe it
down with a damp, soft cloth. Then dry
it with a soft cloth.
15176_DE-EN_A5_V1.indb 1315176_DE-EN_A5_V1.indb 13 02.07.2024 09:53:0402.07.2024 09:53:04
Bekijk gratis de handleiding van Cleanmaxx 15176, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cleanmaxx |
| Model | 15176 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 2121 MB |
