Cleanmaxx 07948 handleiding
Handleiding
Je bekijkt pagina 20 van 48
EN
7
3. Flip open the seal cap of the fresh water
container (9) and pour in carpet cleaning
agent. Note the dosing instructions for
the cleaning agent when you do this.
4. Fill the fresh water container up to the
Max mark with warm water (max. 40°C).
Close the seal cap again.
5. Insert the fresh water container into the
container support (14) (see the “ Before
Initial Use” chapter).
Cleaning
Please Note!
■ The device should only be used if it has
been fully and correctly assembled! Both
the dirty water tank and the fresh
water tank must be firmly closed
and inserted!
■ Only connect the device to a plug socket
that is properly installed. The plug socket
must also be readily accessible after
connection so that the connection to the
mains can quickly be isolated. The mains
voltage must match the rating plate of
the device.
■ Always switch off the device first before
the plug is pulled out of the plug socket.
One exception is when the device has
fallen into water or in the event of a fault.
■ Switch off the device before a water
container is removed.
■ Make sure that the device does not tip
over. The water from the water contain-
ers could spill out. To park the device,
move the handle to the vertical position
in which it engages.
■ Do not wet the carpet or the upholstered
furniture excessively.
■ If the device switches off during use, the
built-in overheating protection has been
activated. In this case, let the device
cool down for approx. 60 minutes and
then switch it on again using the On / Off
switch.
■ After use, place the device down on
a cloth as residual water may escape
from the nozzles after it has been
switched off.
Cleaning the Carpet
1. Decide where cleaning should start
and where it should stop so that you
do not step on the carpet which has
already been cleaned. We recommend
that right-handed people should start at
the right-hand edge of the carpet, and
left-handed people should start at the
left-hand edge of the carpet.
2. Fully unwind the mains cable from the
hook for winding up the cable (10, 11),
insert it into the cable holder (16) and
connect it to a plug socket.
3. Step on the pedal for tipping the
handle(13) and tilt the handle(1)
towards you.
4. Step on the On / Off switch (12) to
switch on the device.
5. Roll the device to a corner of the carpet.
6. Slide the device forwards along the
edge of the carpet and hold down the
button for discharging the cleaning
solution(17). This applies the solution
to the carpet and brushes it in. Walk to
the side of the device as you do this.
Donot tread on the wet carpet!
Once you have reached the other end
ofthe carpet, let go of the button.
7. Pull the device backwards along the same
strip. The dirty water will be sucked up.
8. Start the next strip slightly overlapping
the strip of carpet that has just been
cleaned. Work up to the other edge of
the carpet with even movements for-
wards and backwards. If you find more
Bekijk gratis de handleiding van Cleanmaxx 07948, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cleanmaxx |
| Model | 07948 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 5920 MB |
