Claypaky Skylos handleiding

Niet gecategoriseerd

Claypaky

20 pagina's

PDF beschikbaar

Handleiding

IP66

ta 45 °C

30 m

IP66

ta 45 °C

30 m

Reversal of the display - Fig. 10

To activate this function, press UP

and DOWN

keys simultaneously while the display is in the rest mode. This status will be memorized and

maintained even for the next time it will be switched on. To return to the initial state, repeat the operation all over again.

Setting the luminaire starting address.

On each luminaire, the starting address must be set for the control signal (addresses from 1 to 512).

The address can also be set with the luminaire switched off.

Setting the luminaire Fixture ID.

On each luminaire, the Fixture ID address must be set for an easy identification of the fixtures in an installation (ID from 1 to 255).

The Fixture ID address can be set with the luminaire switched off.

SKYLOS

Switching on the luminaire - Fig. 9

Ensure that the fixture is not remotely controlled, by disconnecting DMX cable during this operation, to prevent unwanted light emission.

Switch-on the fixture. The luminaire starts resetting the effects. At the same time, the following information scrolls on the display:

Model Firmware xxx (Fixture ID) System errors

Skylos Version X.X.X DMX Address xxx E: .........................

Date - Hour W: .........................

On conclusion of resetting in case of absence of the DMX signal, Pan and Tilt move to the “Home” position (Pan 128 bit - Tilt 128 bit). The control panel

(Fig. 8) has a display and buttons for the complete programming and management of the luminaire menu. The display can be in one of two conditions:

rest status and setting status. When it is in the rest status, the display shows the luminaire’s DMX address and the Fixture ID address (if set).

During menu setting status, after a wait time (about 30 seconds) without any key having been pressed, the display automatically returns to rest status.

It should be noted than when this condition occurs, any possible value that has been modified but not yet confirmed with the

key will be cancelled.

WAR NING : MINIMUM DIS T ANCE OF INF LAMMABLE

MATE RIALS FROM THE S UR FACE 0.20 m.

DO NOT OPERATE WITHOUT COMPLETE LIGHT

SOURCE ENCLOSURE IN PLACE OR WHEN LENSES

ARE DAMAGE D.

SERVICE SHOULD BE PERFORMED ONLY BY

QUALIFIED PERSONNEL AS DETERMINED BY THE

LUMINAIRE MANUFACTURER.

NOT FOR RESIDENTIAL USE.

SUITABLE FOR WET LOCATIONS.

ATTENTION: LAISSER UNE DISTANCE D'AU MOINS

0.20 m ENTRE LA SOUR CE LUMINEUSE E T TOUTE

SURFACE COMBUSTIBLE.

NE PAS UTILISEZ SANS AVOIR INSTALLÉ UNE

COUVERTURE COMPLÈTE DE LA LAMPE OU SI LES

LENTILLES SONT ENDOMMAGÉES.

LE S OPÉR ATIONS D'ASSIS TANCE DE VRONT Ê TR E

EFFECTUÉES EXCLUSIVEMENT

PAR DU PERSONNEL QUALIFIÉ CONFORMÉMENT

AUX CONSIGNE SDU FABR ICANT DU LUMINAIR E.

NON INDIQUÉ POUR UN UTILIS ATION DOMESTIQUE .

CONVIENT AUX EMPLACEMENTS MOUILLES.

IP66

ta 45 °C

30 m

Dmx

Address

Warning

Message

Fixture ID

3.4 Switching on the fixture and basic SetUp

Bekijk gratis de handleiding van Claypaky Skylos, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.