Cigweld BlueVenom 4R-Rover handleiding
Handleiding
Je bekijkt pagina 62 van 72
PROBLEM CAUSE REMEDY
5 Unit will not feed wire in MIG mode. A Incorrect Feed Roll tted for wire type
being used.
A Fit the correct feed roll for MIG wire type
being used. Refer to section 2.10 for
optional feed rolls available and Section
5.09 for feed roll tting details.
B Pressure Roller Arm is not secured in
the correct position or not correctly
adjusted.
B Secure Pressure Roller in the correct
position and ensure that it is correctly
adjusted. Refer to Section 5.07 and 5.08.
C Electrode wire stuck in conduit liner or
contact tip (burn-back jam).
C Check for clogged / kinked MIG Gun conduit
liner or worn contact tip. Replace faulty
components.
D Internal fault in power source D Have an Accredited CIGWELD Service
Provider investigate the fault.
6 Welding wire continues to feed
when MIG Gun trigger is released.
A MIG Gun Trigger in 4T Mode A Change MIG Gun Trigger Mode to 2T.
B MIG Gun trigger leads shorted, or
faulty MIG Gun Trigger.
B Repair or replace MIG Gun trigger switch/
lead.
7 Welding arc cannot be established
in MIG mode.
A MIG Gun polarity lead is not connected
into a welding output terminal.
A Connect the MIG Gun polarity lead to either
the positive welding output terminal or
the negative welding output terminal as
required. Refer to Section 4.10.3.
B Poor or no work lead contact. B Clean work clamp area and ensure good
electrical contact.
8 Inconsistent wire feed. A Worn or dirty contact tip. A Replace if necessary.
B Incorrect or worn feed roll. B Replace if necessary.
C Excessive brake tension on wire reel
hub.
C Reduce brake tension on spool hub.
D Worn, kinked or dirty conduit liner D Clean or replace conduit liner.
E Pressure Roller Arm is not secured
in the down position or not correctly
adjusted.
E Secure Pressure Roller in the down position
and ensure that it is correctly adjusted.
Refer to Section 5.07 and 5.08.
9 No gas ow in MIG mode. A Gas hose is damaged. A Replace or repair.
B Gas passage contains impurities. B Disconnect gas hose from the rear of power
source and blow out impurities.
C Machine set in MIG Gasless mode. C Set Machine to MIG Gas mode.
D Empty gas cylinder. D Replace gas cylinder.
E Cylinder Valve not turned on. E Turn Cylinder valve in anticlockwise
direction until gas is owing.
10 Gas ow continues after the
MIG Gun trigger switch has been
released (MIG Gas Solid mode).
Gas valve has jammed open due to
impurities in the gas or the gas line.
Have an accredited CIGWELD service
provider repair or replace gas valve.
62 | CIGWELD.COM.AU
OPERATING MANUALBLUEVENOM 4R-ROVER
Bekijk gratis de handleiding van Cigweld BlueVenom 4R-Rover, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cigweld |
| Model | BlueVenom 4R-Rover |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11536 MB |
