Cigweld BlueVenom 4R-Rover handleiding
Handleiding
Je bekijkt pagina 47 van 72
5.14 MIG QUICKSET MODE
A
B
C
D E
F
G
I J
K
L
H
M
Figure 5-18: MIG QuickSet Mode
A
MODE SELECTION BUTTON
Select Remote Feeder, Spool Gun or Push-Pull Gun mode.
B
PROCESS SELECTION BUTTON
SELECT MIG QUICKSET MODE
QuickSet Plate Thickness, Wire Diameters or Gases available
depend on options selected.
C
LEFT CONTROL KNOB
PRESS TO STEP THROUGH AND SELECT OPTIONS IN MIG
QUICKSET MODE
QuickSet Plate Thickness, Wire Diameter (mm) ,
Material Type (MTL), and Wire Feed Speed (WFS)
Once desired function selected use the Right Control Knob to
select or turn clockwise to increase or counterclockwise to
decrease value.
D
QUICKSET PLATE THICKNESS
INDICATOR
When illuminated the Material Plate Thickness is able to be
selected. Plate Thicknesses are shown on the Digital Display.
Use the Left Control Knob to select and adjust. Available Plate
Thicknesses will be determined by the MIG Wire Diameter and
Material Type Selected. Refer to QuickSet Programme List
Page 48.
E
WIRE DIAMETER INDICATOR
QuickSet wire diameters available depend on Plate Thickness
and Material type selected.
F
MATERIAL TYPE INDICATOR
When illuminated the type of Welding Material is able to be
selected. Material Types are displayed across both Digital
Displays. Refer to QuickSet Programme List Page 48.
G
WIRE FEED SPEED
If the Welding Current is found to be too High or too Low for
the application the Wire Feed Speed can be adjusted to the
desired value. Once WFS function is selected by pressing the
OPERATING MANUAL BLUEVENOM 4R-ROVER
CIGWELD.COM.AU | 47
Bekijk gratis de handleiding van Cigweld BlueVenom 4R-Rover, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cigweld |
| Model | BlueVenom 4R-Rover |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11536 MB |
