Cigweld BlueVenom 4R-Rover handleiding
Handleiding
Je bekijkt pagina 43 van 72
NOTE
Wirefeeder settings are adjusted using the front panel controls. Refer to Section 4.02 Indicators and Controls, Section
5.14 MIG QuickSet Mode or Section 5.15 MIG Manual Mode.
WARNING
Before connecting the work clamp to the work piece make sure the mains power supply is switched off.
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being fused in the terminal.
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the Welding Power Source.
WARNING
Moving Parts can cause injury!
Positive Welding Terminal (+)
Negative Welding Terminal (-)
Work Lead
PulseMate
Spool Gun
PulseMate
Shielding Gas Cylinder
3P - 400VAC
Mains Supply
8 pin Remote
Control Socket
Control Cable
(10 Pin)
Welding Power Cable
10 Pin Remote
Control Socket
Welding Power
Terminal
5 Pin PulseMate
Control Socket
Shielding Gas Inlet
Supply Input Lead
Gas Hose
BlueVenom Wheeled
Power Source
10 Pin Wirefeeder
Socket (Remote Feeder)
Figure 5-15: Setup with Spool Gun for Gas Shielded MIG Wire
OPERATING MANUAL BLUEVENOM 4R-ROVER
CIGWELD.COM.AU | 43
Bekijk gratis de handleiding van Cigweld BlueVenom 4R-Rover, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cigweld |
| Model | BlueVenom 4R-Rover |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11536 MB |
