Chapin 97561 handleiding
Handleiding
Je bekijkt pagina 11 van 36
SPRAY & PUMP FAQ
Chapin Spot Sprayer Operator’s Manual - English
1. Why does the pump not run all the time?
This is a demand pump and only runs with flow; a specific pressure must be reached
before the pump turns off.
2. Why does the pump surge while using the spray wand?
Low flow may cause the pump to surge (or cycle). This could happen when the spray
wand is adjusted for a small or fine spray pattern. To overcome, slightly open the by-
pass valve, or adjust the nozzle to allow more flow.
3. How do I adjust the pressure?
Pressure should be adjusted by regulating the by-pass valve (slightly opening or
closing).
4. My pump quit and will not restart - what should I check?
Check all electrical connections. Ensure switch is in the on position. Check in-line
fuse and/or fuse in car adapter end. Ensure correct voltage +/- 10%. 12-14 volt
5. Low flow or no flow at all - what should I check?
Check for a clogged suction hose and/or suction strainer. Often you will need to clean
the suction strainer. Check for proper voltage. Check for crimped hosing.
6. Is there a fuse for the sprayer?
Yes, in-line to the 12V wiring harness.
7. What size fuse should I use as a replacement?
10 amp
8. How should I clean the tank after use?
• Rinse tank thoroughly with water only, empty, refill with water.
• Open shut-off and allow water to run through discharge assembly. Empty
sprayer.
• If the unit is to be stored below freezing the best way to winterize is to run RV
antifreeze through both lines before storage, then purge with water in the spring.
10E
5
9
6
10
11
14
16
12
13
2
3
4
8
15
7
1
Bekijk gratis de handleiding van Chapin 97561, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Chapin |
| Model | 97561 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5083 MB |
