Champion CG208 handleiding
Handleiding
Je bekijkt pagina 23 van 50
15
Troubleshooting
Problem Cause(s) Solution(s)
Water flows into glasswasher
when ON/OFF switch is in the
OFF position.
FLowing water supply line
pressure measured at the
glasswasher exceeds 95 PSI
(655 kPA).
Defective solenoid valve(s).
Defective AUTO-FILL switch.
Incoming water pressure
must be 5 PSI/35 kPa on
pressure gauge located on
right-side of glasswasher
lower compartment.
Authorized Service Agent
may rebuild or replace
solenoid valve(s).
Service Agent may replace
the switch.
Chemical(s) are not flowing
into the glasswasher.
Rinse water pressure too high.
Chemical container(s) are empty.
Chemical supply line(s) are
clogged.
Chemical supply and/or pump
tube(s) are broken.
No power to chemical
dispensing pump(s).
Dispensing pump is defective.
Chemical pumps out of
adjustment.
Reduce flowing water
pressure measured at the
glasswasher below 95 PSI
(655 kPa).
Refill the container(s).
Remove the supply
line(s) from the chemical
container(s) and flush with
warm water.
Replace supply line(s) and/
or pump tube(s).
Authorized Service Agent
may replace chemical
dispensing pump.
Authorized Service Agent
must inspect and repair.
Chemical supplier must
adjust chemical pumps.
Bekijk gratis de handleiding van Champion CG208, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Champion |
| Model | CG208 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 4960 MB |
