Champion 100427 handleiding
Handleiding
Je bekijkt pagina 16 van 17
13
ENGLISH 100427
TROUBLESHOOTING
Problem Cause Solution
Motor does not turn on
Switch assembly not connected
properly.
Insert switch assembly all the way into the connector.
Loose battery cable
connections.
Tighten nuts on all cable connections.
Contactor malfunctioning.
Tap contactor to loosen contacts. Apply 12 volts to
coil terminals directly. A clicking indicates proper
activation.
Defective switch assembly. Replace switch assembly.
Defective motor.
Check for voltage at armature port with switch
pressed. If voltage is present, replace motor.
Water has entered motor.
Allow to drain and dry. Run in short bursts without
load until completely dry.
Motor runs but cable
drum does not turn
Clutch (cam ring) not engaged.
Move cam ring to the "In" position. If problem
persists, a qualied technician needs to check and
repair.
Motor runs slowly or
without normal power
Insufcient current or voltage.
The battery is weak; recharge. Run winch with vehicle
motor running (battery should have a strong charge).
Loose or corroded battery cable
connections.
Clean, tighten, or replace.
Motor overheating Winch running time too long. Allow winch to cool down periodically.
Motor runs in one
direction only
Defective or stuck contactor
Tap contactor to loosen contacts
Repair or replace contactor
Defective switch assembly Replace switch assembly
For further technical support:
Technical Service
Mon – Fri 8:30 AM – 5:00 PM (PST/PDT)
Toll Free: 1-877-338-0999
tech@championpowerequipment.com
Bekijk gratis de handleiding van Champion 100427, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Champion |
| Model | 100427 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2051 MB |
