Handleiding
Je bekijkt pagina 9 van 34
EN
CI+Slot
CAM
SmartCard
1 Turn on the TV and ensure ‘DTV’ Source is selected
2 If the CAM is detected the TV will display the following
message on the screen. “Common Interface Module
inserted “wait for a few moments until the card is
activated
3 Select the relevant digital Pay Per View channel
4 Detailed information on the Smart Card in use is dis-
played
5 Press the Ok button to access the card menu. Refer to
the Module Instruction Manual for setting details
6 When the module is removed, the following message
will appear on the screen. “Common Interface module
Press the power button on the LED TV or the POWER but-
ton on the remote control, the standby indicator will light
green
To turn off the LED TV
Press the power button on the LED TV or the POWER but-
ton on the remote control, the standby indicator will light
red
When you initially turn on the LED TV you will see the fi rst
timeinstallationmenuasbelow
ATV (Analogue Television) is used for Analogue Cable
systems
DVB (DTT - Digital Terrestrial Television, DVB-T) is used if
you have an antenna receiving signals from a terrestrial
transmitter
Cable is used for Digital Cable sy
stems (DVBC)
Satellite dex if a deen uoY .E2.91 artsA
rofteserp si dish
with a univ
ersal LNB. To install any other satellites use
the full satellite installation menu
the Conditional Access Module (CAM) and Smart Card
in order to view the pay TV programmes and additional
services. Contact your Pay Per View TV service provider
to get more information about the modules and subscrip-
tions
NOTE: Conditional Access Module and Smart Cards are
sold separately
WARNING! SWITCH OFF YOUR TV BEFORE ANY MODULE
IS INSERTED INTO THE COMMON INTERFACE SLOT,
THEN ADD THE SMART CARD TO THE CAM
Ensure your aerial, cable or dish is plugged in to the TV
and then press OK again
The TV will start to install the service you have selected
This could take some time depending on your selected
service
You can tune an additional service at any time by pressing
the Quick Start button.
CommonInterfaceSlot
USING YOUR COMMON INTERFACE SLOT
This TV set features a CI+ slot and supports the following
digital standards: DVB-T, DVB-S(S2) and DVB-C.
Common Interface
The Common Interface (CI+) slot is designed to accept
removed“.
Auto installation setup
Power On / Off the LED TV
To turn on the LED TV
Press OK button and you will see the following menu.
Select Home mode and confirm with OK button.
Use the left/Right/Down keys to select your language
and country use the up/down keys to select the type of
service you want to install. You can only install one service
at a time but you can return to this menu in order to install
an additional service by pressing the Quick Start button.
Bekijk gratis de handleiding van Cello LED2612QD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cello |
| Model | LED2612QD |
| Categorie | Televisie |
| Taal | Nederlands |
| Grootte | 10650 MB |
