Cecotec Conga Rockstar P50 handleiding
Handleiding
Je bekijkt pagina 6 van 33
1110
CONGA ROCKSTAR P50CONGA ROCKSTAR P50
ENGLISH ENGLISH
then remove the locking pin to release the roller and remove it.
Charging
If you are not going to use the vacuum cleaner for an extended period, fully charge it once a
month to prevent battery inactivity.
5. TROUBLESHOOTING
Problem Possible cause Possible solution
The vacuum cleaner
does not work
The battery is
discharged.
Charge the battery.
The battery has reached
the end of its useful life.
The battery must be replaced. To
do this, contact Cecotec’s Ocial
Technical Support Service.
The connector between
the vacuum cleaner and
the charger is dirty.
Clean and remove dirt from the
connector.
The socket has no
power.
Make sure the plug is properly
connected and there is electrical
power. Try a dierent socket if
necessary.
The charger is not
plugged in.
Connect the charger.
The vacuum cleaner
does not pick up dust;
the suction power has
weakened
The dust container is
full.
Empty the dust container.
The dust lter needs to
be cleaned or replaced.
Remove the dust lter and check for
objects in the air inlet and remove
them. Clean or replace the dust lter.
Low battery. Recharge the vacuum cleaner
completely before use.
assistance is required.
3. OPERATION
Before using the vacuum cleaner for the rst time, make sure the battery is fully charged.
During charging, the LED indicator lights will illuminate one by one until all are lit. Charging
time is approximately 4 hours.
Assembling the suction tube and oor brush head.
- To attach the oor brush head to the suction tube, align both parts so that the tab on the
brush head matches the guides on the tube, and insert the tube into the brush head until
it clicks into place.
- To disassemble them, press the oor brush release button and pull the suction tube while
rmly holding the brush head.
Assembling the suction tube, oor brush head and main body.
To complete the vacuum cleaner assembly, once the oor brush head is attached to the suction
tube, keep the tube in a vertical position and insert it into the main body.
This vacuum cleaner can be used in two dierent ways:
- As a handheld vacuum cleaner, by attaching accessories directly to the main body.
- As an upright vacuum cleaner, using the suction tube with accessories attached to it.
Press the power button to turn on the vacuum cleaner and the mode button to switch between
the 3 available settings: low, medium and high.
4. CLEANING AND MAINTENANCE
Emptying the dust container
Press the dust container opening button to open the lid and empty the container.
Cleaning the ltration system
You can rotate the lter system by hand to remove it.
Press the button, and the lter frame will automatically release. Then move it upwards and
remove the lter.
Cleaning the oor brush head
If the brush roller is blocked, you can remove and clean it. Press the lock button to “unlock”,
Bekijk gratis de handleiding van Cecotec Conga Rockstar P50, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cecotec |
| Model | Conga Rockstar P50 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 3748 MB |
