Cecotec Bolero Squad G 2200F handleiding
Handleiding
Je bekijkt pagina 85 van 248
BOLERO SQUAD G 1200F / 2200F / 3200F / 4200F / 5200F INOX
85
ENGLISH
Switching o a burner
To switch a burner o, turn its corresponding operation knob clockwise to the o position (0/
OFF).
Note:
- It is normal to hear a slight crackling noise during burner operation.
- It is normal for it to give o a strange smell during the rst use. This is not dangerous and
does not indicate any malfunction. These phenomena will disappear on their own.
- An orange ame is normal. This is due to dust or splashes of liquid in the environment.
- If the ame goes out accidentally, turn the burner knob to the o position (0/OFF). Wait at
least one minute before relighting the burner.
- A few seconds after the burner has been switched o, you will hear a “knock” sound. This is
not a problem; it is simply that the security system has stopped working.
- Keep the burner as clean as possible. If the ignition needle is dirty, no ame will ignite. Use
a soft brush to clean this part regularly. Avoid knocking or hitting the ignition needle.
5. CLEANING AND MAINTENANCE
Warning: Explosion risk
Before cleaning the hob, make sure that it has cooled down completely and that
the gas valve is not supplied. Do not disassemble the safety system or watertight
components.
When removing the burner cap, be careful not to strike the ignition needle to prevent it from
cracking (Fig. 10).
Cleaning the panel and burner cap
Use a damp cloth or a very soft scouring pad. Do not use metallic scouring pads or scouring
pads with rough or coarse surfaces or acidic cleaning agents.
Pan supports, caps and burners are not dishwasher safe.
Burner cleaning
It is recommended to clean the burner and its cap at least once a month. Especially if the ame
is irregular. Remove the burner and use a steel needle to remove dirt and carbon deposits from
the burner holes (Fig. 11).
Do not rinse the burner directly with water. Make sure it is completely dry before using it again.
Cleaning the ignition needle and thermocouple
Use a soft brush to clean the surface of the ignition needle and thermocouple.
Avoid knocking or hitting the ignition needle during cleaning. After cleaning, make sure that all
parts are dry and then install them correctly.
Bekijk gratis de handleiding van Cecotec Bolero Squad G 2200F, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Cecotec |
| Model | Bolero Squad G 2200F |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 26589 MB |
