Cecotec Bolero DressCode 9800 Inverter Steel A Handleiding (398 Pagina's)

Handleiding

/ 398

Je bekijkt pagina 108 van 398

BOLERO DRESSCODE 9800 INVERTER A/ STEEL108

ENGLISH

Connection of the supplied hoses

Water supply hose connection

1. Connect one end of the water supply hose to a cold water tap and tighten by hand (Fig.

6). Before making the connection, allow the water to run freely until it runs completely

clear.

2. Connect the other end of the water supply hose to the water inlet valve at the rear by

turning clockwise (Fig. 7).

3. Open the tap slowly and make sure there are no water leaks.

Warning

- Do not kink, crush, modify or sever the water inlet hose.

- Squeeze the end of the hose rmly by hand.

- The water supply pressure must be within a range between 0.03 and 1 MPa. If

the pressure exceeds this value, a pressure reducing valve (not included) must be

installed.

- If the hose is not long enough, please contact a specialised retailer, an authorised

technician or the Cecotec Service Centre.

- Never use a second-hand or used hose. Always use the hose supplied with the

equipment.

Drain hose connection

Drainage point height (Fig. 8)

Height dierence between the oor and the drain:

- Minimum 60 cm (24 inches)

- Maximum 100 cm (39 inches)

Drainage connection types:

1) To the vertical drainage pipe

Connect the drain hose to the elbow (not included) of the drain pipe. Place the elbow on the

hose 4 inches (100 mm) from the end of the hose. Insert this section of hose into the pipe.

If the hose is pushed down too far, it can cause the washing machine to self-siphon, i.e.

to continuously empty as it lls with water. Secure the elbow and hose with a hose clamp

(not included) to prevent the hose from slipping out of the tube during use.

Fig. 9

1. Drainage pipe

2. Cold water

/ 398

Bekijk gratis de handleiding van Cecotec Bolero DressCode 9800 Inverter Steel A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.