Cecotec Bolero DressCode 9610 Inverter A Handleiding (492 Pagina's)

Handleiding

/ 492

Je bekijkt pagina 138 van 492

BOLERO DRESSCODE 7610 / 8610 / 9610 / 10610 INVERTER A

138

ENGLISH

- Do not repair or replace any part of the appliance unless specically instructed to do so

in this instruction manual. It may lead to a dangerous incident that endangers your health

and/or damages property.

- In the event of a malfunction, please contact the ocial Cecotec Technical Support Service.

- Use original spare parts.

IMPORTANT: do not come into contact with the following internal components while the

appliance is connected: inlet valve(s), drain pump, motor controller heat sink, PCB.

Errors

Error Cause Solution

E02 No water in Check if the tap is open. If the water supply is cut o. Are the

mesh lter in the water supply hose and the water inlet valve

blocked? What if the water supply hose of the appliance is

frozen? Eliminate the above causes of failure. If the fault code

still exists, please contact the Cecotec Technical Support.

E03 Drain failure Clean the pump lter.

Check if the drain hose is bent, kinked, or blocked. Eliminate

the above causes of failure. If the fault code still exists, please

contact the Cecotec Technical Support.

U4 Door lock fault The door is not closed properly and the door lock does not

function normally. Close the door again, turn the wash cycle

knob to the “OFF” position to turn o the power supply, and

then turn the knob to select any wash programme and press

the START/PAUSE button to restart the programme. Eliminate

the causes of this failure. If the fault code still exists, please

contact the ocial Cecotec Technical Support Service.

If the fault code appears and you cannot open the door, the

door lock may be faulty, please contact the ocial Cecotec

Technical Support Service.

H Drum

temperature is

high

Press the START/PAUSE button to suspend operation of the

appliance and wait a few minutes. When the temperature in the

drum drops to a safe range and the fault code on the display

is cleared, press the START/PAUSE button to continue with

the rest of the programme. If the fault code still exists, please

contact the ocial Cecotec Technical Support Service.

EXX Other errors Turn the knob to turn o the appliance, unplug the power cord

and contact Cecotec Technical Support.

/ 492

Bekijk gratis de handleiding van Cecotec Bolero DressCode 9610 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.