Cecotec Bolero DressCode 9610 Inverter A Handleiding (492 Pagina's)

Handleiding

/ 492

Je bekijkt pagina 127 van 492

BOLERO DRESSCODE 7610 / 8610 / 9610 / 10610 INVERTER A

127

ENGLISH

NOTE:

The actual end time of the wash cycle may be dierent from the set delayed end time,

depending on multiple factors such as water supply pressure, drainage, type of laundry, water

temperature, as well as other conditions.

Steam washing

Press the STEAM button to add a steam wash process after the last water drain stage of the

selected (or ongoing) wash cycle and before the last spin. In the steam washing process, the

machine generates a large amount of high temperature steam that penetrates deep into the

fabric, improving the softness and elasticity of the laundry and, at the same time, eliminates

odour and refreshes the laundry. After the steam washing process, the machine enters the

nal stage of draining and spinning.

The steam wash is compatible with the following programmes:

- Mix

- Cotton

- Quick Wash

- Baby Care

- Bedding

- Underwear

Child Lock

1. The setting of the child lock function can prevent malfunctions or unwanted incidents.

2. During operation, press and hold the SPEED button for approximately 3 seconds to set or

cancel the child lock function.

3. After setting the child lock function, its indicator light comes on, the door cannot be opened

and the control panel is locked, the buttons remain inactive, as well as the wash cycle knob

(the indicator light below the power symbol is on ). The machine can only be switched

o by turning the wash cycle knob to its OFF position, the indicator light below the power

symbol will go out and the device will stop operating. If the machine is switched o, the

child lock function will be cancelled.

4. After setting the child lock function, you can switch o the machine by turning the washing

cycle knob. When the machine is switched on again, it will directly run the selected

programme before it was switched o.

Adding laundry during a washing cycle

When the programme is running, press and hold the START/PAUSE button to pause the

machine. If the DOOR LOCK indicator light goes out, the door can be opened, you can add or

remove laundry. Once the operation is complete, close the door, press, and hold the START/

PAUSE button again and the machine continues to run from the point where it was interrupted.

/ 492

Bekijk gratis de handleiding van Cecotec Bolero DressCode 9610 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.