Cecotec Bolero DressCode 8900 Inverter A handleiding

Wasmachine

Cecotec

468 pagina's

PDF beschikbaar

Handleiding

/ 468

Je bekijkt pagina 130 van 468

Bolero DressCode 8900 Inverter FullColor A

Bolero DressCode 8900 Inverter FullColor Steel A

Bolero DressCode 8900 Inverter FullColor Ice Blue A

130

ENGLISH

Tip: do not operate the appliance without the detergent drawer in place. If the appliance is not

in use, always keep the drawer closed.

Warning

Do not use alcohol, solvents or chemical products.

You can use a soft brush to remove detergent residues adhering to the drawer.

Cleaning the mesh lter in the water supply hose and the water inlet valve

1. Close the tap (stopcock) and unscrew the water supply hose (Fig. 19).

2. Carefully clean the mesh lter at the end of the hose with a ne brush (Fig. 20).

3. Now unscrew the water supply hose at the back of the appliance by hand. Remove the

mesh lter from the water inlet valve at the back of the appliance with needle-nose pliers

(be careful not to damage it) and clean it carefully (Fig. 21).

4. Reinsert the mesh lter back into the back of the washing machine. Reconnect the water

supply hose to the tap and to the appliance. Do not use a tool to connect the inlet hose.

Open the water tap and check that all connections are tight (Fig. 22).

Cleaning the drain pump lter

WARNING: DANGER OF BURNS. Danger of skin injury from hot water!

Take special care when draining water from the appliance and opening the lid.

It is advisable to clean the lter of the drain pump from time to time to ensure that there are

no problems.

The pump of the appliance may become blocked with loose debris (remember to check the

drum and remove visible debris after each load). Fabrics that shed large amounts of lint can

also cause blockages.

To access the drain pump lter, you must rst open the cover on the bottom right-hand side.

Press lightly to open the lid (Fig. 23). With the lid open, proceed as follows:

1. If the appliance has not been drained, try draining it now. First, turn the washing cycle knob

to select the SPIN programme, press the SPEED icon until the display shows “-”, then press

the START/PAUSE icon. Wait a moment for the pump to drain the water from the drum. If

the pump is totally blocked, the water will not be able to drain, and the cycle will end.

2. Turn o the tap so that no more water enters. Switch o the appliance. Disconnect the

power cord from the plug.

3. Use the removable drain hose located on the lter access opening to drain the remaining

water into a suitable container (up to 20 litres of water can be drained). Remove the plug

from the hose and place it over the side of a suitable container and allow the water to drain

out of the drum. When nished, replace the sealing plug on the end of the hose and return

the hose to its storage location. Be careful not to spill the drained water on the oor (Fig.

24).

/ 468

Bekijk gratis de handleiding van Cecotec Bolero DressCode 8900 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.