Cecotec Bolero DressCode 8610 Inverter A Handleiding (492 Pagina's)

Handleiding

/ 492

Je bekijkt pagina 137 van 492

BOLERO DRESSCODE 7610 / 8610 / 9610 / 10610 INVERTER A

137

ENGLISH

Machine does not drain,

drains slowly or “E03”

appears on the display

The top of the drain hose is too high. It should be installed at a

height of 65-100 cm from the ground.

The draining pump lter is blocked.

Drain hose is kinked or bent.

Drain hose is blocked or frozen.

The wash programme

time stops counting before

entering the high-speed

spin process

This is not an issue. The load balancing system of the

appliance tumbles and scatters the laundry in the drum

for a long time to achieve balance and complete the high

speed spin. In the process of tumbling and scattering, the

programme time stops counting before the appliance reaches

the high-speed spin process.

Washing programme lasts

too long

Programme times will vary due to water pressure, incoming

water, temperature, etc.

If the wash load becomes unbalanced, the time will increase.

Excessive noise There will always be some noise from the motor, pump, and

drum during spinning.

The washing machine touches other objects.

Foreign objects, such as hairpins or metal objects, fall into the

drum.

The machine is

continuously lled with

water and continuously

emptied

The top of the drain hose is too low. It should be installed at a

height of 65-100 cm from the ground.

The end of the drain hose has been pushed too far down into

the standpipe; the hose elbow must be installed 100 mm from

the end of the drain hose.

The end of the drain hose is submerged in the discharged

water.

The drained water returns

to the machine

If the end of the drain hose touches the discharged water

(water drained from the washing machine), it (the discharged

water) may be sucked back into the appliance and damage the

appliance or garments.

Control panel gets hot This is a slight heating eect of the electronic components on

the PCB board installed on the back of the control panel.

General issues Your appliance contains sensors that monitor progress during

the wash cycle (e.g. water level, temperature, unbalanced

loads, wash time/progress). Normally, if your appliance

completes the cycle successfully, it is unlikely that there will

be a problem.

/ 492

Bekijk gratis de handleiding van Cecotec Bolero DressCode 8610 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.