Cecotec Bolero DressCode 7610 Inverter A Handleiding (492 Pagina's)

Handleiding

/ 492

Je bekijkt pagina 113 van 492

BOLERO DRESSCODE 7610 / 8610 / 9610 / 10610 INVERTER A

113

ENGLISH

- Before washing the clothes for the rst time, the product shall be operated in one round of

the whole procedures without the clothes inside.

- Make sure that all pockets are empty. Sharp and rigid items such as coins, brooches, nails,

screws, or stones may cause serious damage to this machine.

3. PRODUCT INSTALLATION

1. Place the device on a at, stable and dry surface. Make sure the product does not stand

on the power cord.

2. Never install it on a soft carpet or wooden oor, or on any kind of mezzanine.

3. The washer may move a little during operation due to overload factors.

4. Avoid direct sunlight and ensure sucient ventilation.

5. Keep the room environment dry and avoid humidity.

6. Remove the cardboard box and the extruded polystyrene packaging.

7. Free the power cable and the drain hose from the rear.

8. Remove any accessories that may be inside the drum, such as the water supply hose,

instruction manual, etc.

9. The washing machine should be operated within a temperature range of 5-40 °C. If used

under 0 °C, the inlet valve and draining system may be damaged.

10. Install the appliance ensuring sucient space around it (Fig. 4):

a: minimum 3 cm.

b: minimum 5 cm.

c: minimum 5 cm on the left side.

d: minimum 5 cm on the right side.

e: minimum 70 cm.

CAUTION: do not allow metal parts of the appliance to come into contact with metal sinks or

other appliances.

Removing the transport screws (Fig. 3)

- The transport bolts must be removed from the backside of the device before using it.

- IMPORTANT: it is imperative to remove the transport screws before the rst use, otherwise

they may damage the drum during the operation of the device.

- The transport screws will be necessary again when moving the product, so make sure they

are kept in a safe place.

- In order to remove the screws:

- Loosen 4 screws with a spanner and then remove them (A).

- Remove the 4 tube spacers (depending on model) (B).

- NOTE: during removal of the transport screws, occasionally the pipe spacers may fall into

the machine, if this happens, they can be accessed by tilting the machine forward and

picking them up from the oor or inside the base of the machine.

/ 492

Bekijk gratis de handleiding van Cecotec Bolero DressCode 7610 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.