Cecotec Bolero Dresscode 7410 Inverter A handleiding

Wasmachine

Cecotec

127 pagina's

PDF beschikbaar

Handleiding

Bolero Dresscode 7410 Inverter A / Bolero DressCode 7410 Inverter Steel A

Bolero Dresscode 8410 Inverter A/ Bolero DressCode 8410 Inverter Steel A

Bolero Dresscode 9410 Inverter A/ Bolero DressCode 9410 Inverter Steel A

Bolero Dresscode 10410 Inverter A/ Bolero DressCode 10410 Inverter Steel A

Bolero Dresscode 7410 Inverter A / Bolero DressCode 7410 Inverter Steel A

Bolero Dresscode 8410 Inverter A/ Bolero DressCode 8410 Inverter Steel A

Bolero Dresscode 9410 Inverter A/ Bolero DressCode 9410 Inverter Steel A

Bolero Dresscode 10410 Inverter A/ Bolero DressCode 10410 Inverter Steel A

7776

ENGLISH ENGLISH

the remaining water inside the drain hose and water inlet hose.

3. Refer to a technician if the washing machine freezes. If the washing machine still does

not work after the above procedure, please contact the ocial Cecotec Technical Support

Service.

6. TROUBLESHOOTING

PROBLEMS POSSIBLE SOLUTIONS

There’s water in the drum

before rst use.

This is normal. It’s the result of factory water tests.

The washing machine does

not turn on.

Check that the plug is properly connected to the socket.

Check if the tap is open.

Check if the Power button was pressed.

Check if the Start/Pause button was pressed.

Check if the Delay Start function is enabled.

The washing machine leaks. Check and tighten the water inlet hose.

Clean the drain hose and contact the ocial Cecotec

Technical Support Service.

Strange noise and strong

vibrations.

Check whether the transport bolts have been removed.

Check if the levelling feet are properly adjusted. Check if the

washing machine is installed on a level and solid surface.

Check for metal items inside.

Washing results are not

satisfactory.

Select a suitable washing programme.

Add the appropriate amount of detergent according to the

instructions on the detergent package.

The buttons do not work. Check whether the “Child Lock” function is enabled.

The actual running time

of the programmes does

not correspond to the time

indicated on the display.

Check if the laundry in the drum is evenly spread out.

Check if the water ows in and out properly.

The washing machine lls up

during draining.

Check if the height of the drain hose is less than 65 cm.

Check if the drain hose is submerged.

2. Unscrew the plug and remove any foreign material or objects from the drain outlet. Be

careful with possible water that may come out during the process. Fig. 17

3. Ret the plug and close the cover. Fig. 18

Cleaning the water inlet valve lter

The inlet lter must be cleaned if no or insucient water enters when the tap is opened.

1. Lower the water pressure:

a. Close the tap.

b. Select any programme except Spin.

c. Press the Start/Pause button and keep the programme running for about 40 seconds.

d. Disconnect the plug.

2. Disconnect the inlet hose from the tap. Fig. 19

3. Gently pull out the lter using a pair of needle-nosed pliers. Use extreme caution not to

force the lter to avoid damaging it. Fig. 20

4. Wash the lter with water and remove any accumulated dirt.

5. Place the lter back in its original position.

6. Reconnect the inlet hose. Fig. 21

Cleaning the detergent drawer

1. Open the detergent drawer (lift it up slowly) and remove the cover 1 (siphon plate) by

lifting it up as shown in gure 22.

2. Wash the detergent drawer and the siphon with tap water or clean them with a brush.

3. Ret the detergent drawer and the siphon.

- It’s possible for some detergent to get into the drum when removing the detergent drawer.

This is normal.

- To avoid spillage, make sure that no water, detergent, or softener is left in the detergent

drawer before removing it.

Defrost

Do not expose the washing machine to temperatures below 0 °C, as this may aect its operation

and the lifespan of its parts. Should you notice frozen parts, follow the below procedure:

1. Turn o the washing machine and unplug the power cord.

2. Pour hot water over the tap to loosen the water inlet hose.

3. Disconnect the water inlet hose and immerse it in hot water.

4. Pour hot water into the drum and leave it for about 10 minutes.

5. Reconnect the water inlet hose to the tap.

Please note

1. When resuming use of the washing machine, make sure that the ambient temperature is

above 0 °C.

2. If the washing machine is located in a room where it can easily freeze, thoroughly drain

Bekijk gratis de handleiding van Cecotec Bolero Dresscode 7410 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.