Cecotec Bolero DressCode 10900 Inverter A Handleiding (400 Pagina's)

Handleiding

/ 400

Je bekijkt pagina 106 van 400

BOLERO DRESSCODE 10900 INVERTER FULLCOLOR A

BOLERO DRESSCODE 10900 INVERTER FULLCOLOR STEEL A

BOLERO DRESSCODE 10900 INVERTER FULLCOLOR ICE BLUE A

106

ENGLISH

- Keep the transport screws properly for future use. You will need them again if the

washing machine needs to be moved to another location.

- If it is necessary to transport it to another location:

1. Reinstall the transport screws.

2. Secure the power cable to the rear of the appliance.

Levelling the washing machine

- The appliance reaches high spin speeds to remove water at the end of the washing

cycle.

- Therefore, it is important that it is level and that all 4 legs press against the oor with

the same pressure.

- This will help to ensure quieter operation and less vibration.

Carry out the following steps

- Install the appliance on a solid, level surface. Preferably in a corner of the room.

- If the oor is uneven, adjust the legs as necessary to level the device. Do not place any

objects under the legs in an attempt to level it.

- Do not extend the legs more than necessary. The more extended, the more vibrations

the device will suer. Start with the legs all the way in and adjust each one as

necessary.

- You can use a spirit level (not included) to check that the appliance is level.

- Press down on each corner of the top of the equipment to ensure that it does not

“wobble”.

- All legs must press equally against the oor.

- When the device is level and does not wobble, lock the legs by tightening the lock nuts

against the bottom of the equipment. Be sure to do this without changing the height

of the leg (hold the leg while tightening the lock nut). Fig. 5

Connection of the supplied hoses

Water supply hose connection

- Connect one end of the water supply hose to a cold water tap and tighten by hand (Fig.

6). Before making the connection, allow the water to run freely until it runs completely

clear.

- Connect the other end of the water supply hose to the water inlet valve at the rear by

turning clockwise (Fig. 7).

- Open the tap slowly and make sure there are no water leaks.

Warning

- Do not kink, crush, modify or sever the water inlet hose.

- Squeeze the end of the hose rmly by hand.

/ 400

Bekijk gratis de handleiding van Cecotec Bolero DressCode 10900 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.