Cecotec Bolero DressCode 10500 Inverter A Handleiding (228 Pagina's)

Handleiding

/ 228

Je bekijkt pagina 72 van 228

BOLERO DRESSCODE 10500 INVERTER A

BOLERO DRESSCODE 10500 INVERTER STEEL A

72

ENGLISH

remove dirt from the surface. Make sure that the surface of the washing machine remains

dry at all times. Do not scratch the washing machine with sharp objects.

2. The surface can be cleaned with diluted non-abrasive, neutral detergents if necessary.

Cleaning the drain outlet

1. Open the drain-outlet cover as shown in Figure 14. You can open it with the help of a

non-sharp, non-cutting object.

2. Unscrew the plug and remove any foreign material or objects from the drain outlet. Be

careful with possible water that may come out during the process. Fig. 15

3. Ret the plug and close the cover. Fig. 16

Cleaning the water inlet valve lter

The inlet lter must be cleaned if no or insucient water enters when the tap is opened.

1. Lower the water pressure:

a. Close the tap.

b. Select any programme except Spin Only.

c. Press the Start/Pause button and keep the programme running for about 40 seconds.

d. Disconnect the plug.

2. Disconnect the inlet hose from the tap. Fig. 17

3. Gently pull out the lter using a pair of needle-nosed pliers. Use extreme caution not to

force the lter to avoid damaging it. Fig. 18

4. Wash the lter with water and remove any accumulated dirt.

5. Place the lter back in its original position.

6. Reconnect the inlet hose. Fig. 19

Cleaning the detergent drawer

1. Open the detergent drawer (lift it up slowly) and remove the siphon by lifting it up as

shown in Figure 20.

2. Wash the detergent drawer and the siphon with tap water or clean them with a brush.

3. Ret the detergent drawer and the siphon.

- It’s possible for some detergent to get into the drum when removing the detergent drawer.

This is normal.

- To avoid spillage, make sure that no water, detergent, or softener is left in the detergent

drawer before removing it.

Defrosting

Do not expose the washing machine to temperatures below 0°C, as this may aect its operation

and the lifespan of its parts. Should you notice frozen parts, follow the below procedure:

1. Turn o the washing machine and unplug the power cord.

2. Pour hot water over the tap to loosen the water inlet hose.

3. Disconnect the water inlet hose and immerse it in hot water.

/ 228

Bekijk gratis de handleiding van Cecotec Bolero DressCode 10500 Inverter A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.