Cecotec Bolero Aguazero 6210 D Handleiding (398 Pagina's)

Handleiding

/ 398

Je bekijkt pagina 86 van 398

BOLERO AGUAZERO 6210 D

BOLERO AGUAZERO 6210 INOX D

BOLERO AGUAZERO 6210 DARK D

86

ENGLISH

Adjustment of the descaling system

Adjust the descaler according to the hardness level of the water supplied. The descaling

system has 9 levels of adjustment. The dishwasher has been set to water hardness level H5

when leaving the factory.

Settings for 15 place settings

- Make sure that the dishwasher is switched o and press the Dual Zone icon for 3 seconds

to set the programme.

- Press the Dual Zone icon. The current conguration will be displayed.

- Press the Dry+ function icon and select the desired value. The range of values that can be

selected is from H0 to H8.

- Once the necessary settings have been made, press the Power icon to switch o the

dishwasher and save the settings.

Add salt

WARNING:

- The salt tank of the dishwasher must be full before starting the washing programme. If

there is not enough salt, the corresponding indicator light will light up, unless the hardness

level is set to H0.

- After lling the salt tank, it is recommended to start a washing programme immediately.

This will remove the salt accumulated around the inner cylinder and prevent corrosion.

To add salt, follow these steps:

1. Remove the bottom basket.

2. Turn the salt tank cap counterclockwise to open it (Fig. 20).

3. If you want to use the descaler before starting the dishwasher for the rst time, use the

funnel to add a maximum of 650 g of salt into the salt tank (Fig. 21).

4. Only ll the salt tank with water before using it for the rst time.

5. Ret the cap.

6. Run a washing programme with the dishwasher empty.

WARNING:

- Do not pour detergent into the soft water system.

- Clean any salt that may have accumulated around the cap of the salt tank. Otherwise, the

salt solution could corrode the dishwasher and the tableware.

- Align the cap horizontally and turn it clockwise so that it is correctly xed. If the cap is not

completely xed, the salt solution may leak out of the salt tank and cause corrosion.

- After adding the salt, run a washing programme without tableware inside. Otherwise,

spilled salt may cause rust or damage to the dishwasher.

/ 398

Bekijk gratis de handleiding van Cecotec Bolero Aguazero 6210 D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.