Cecotec Bolero Aguazero 6210 D Handleiding (398 Pagina's)

Handleiding

/ 398

Je bekijkt pagina 79 van 398

BOLERO AGUAZERO 6210 D

BOLERO AGUAZERO 6210 INOX D

BOLERO AGUAZERO 6210 DARK D

79

ENGLISH

WARNING:

- If the dishwasher is not correctly levelled, water leakage, problems with closing the door

or some noises may occur.

- If the recess of the cabinet in which the dishwasher is to be installed is narrower than

recommended, the dishwasher must be levelled and aligned correctly; otherwise, water

leakage will occur, you will not be able to close the door or the dishwasher.

- If you notice friction or any problems when opening the door, it means that the dishwasher

is not properly levelled.

Feet adjustment

- The feet should be adjusted as necessary until the dishwasher is completely stable.

- If you wish to raise the dishwasher, adjust the feet clockwise; if you wish to lower it, adjust

the feet counterclockwise.

- Use a at-blade screwdriver or a suitable tool to adjust the feet as shown in gure 5.

Case I: door tilts to the right

1. Unscrew the left rear foot by turning it counterclockwise and level it (Fig. 6).

2. Check that the door opens and closes normally. If not, repeat the previous operation.

Case II: door tilts to the left

1. Unscrew the right rear foot by turning it counterclockwise and level it (Fig. 7).

2. Check that the door opens and closes normally. If not, repeat the previous operation.

Free-standing installation (Fig. 8)

- If the dishwasher is placed in a corner, at least 50 mm must be left free between the

dishwasher and the adjacent wall to ensure that there is sucient space for the door to be

opened and closed without diculty.

- If necessary, it can also be reinforced using wooden slats (not included). Fig. 9

WARNING:

- Place the dishwasher on a rm, at oor.

- Do not install the dishwasher on a raised surface.

Installation under a worktop (Fig. 10)

- Please note that you may need holes on both sides to allow the hoses and power cable to

pass through (approx. 100 mm x 75 mm).

- One of the holes should be as close as possible to the sink to facilitate the connection of

the water inlet and drain hose.

- To ensure trouble-free drainage, the distance between the dishwasher and the sink should

not exceed 1 m.

/ 398

Bekijk gratis de handleiding van Cecotec Bolero Aguazero 6210 D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.