Cecotec BelleCouture OverLock Handleiding (208 Pagina's)

Handleiding

/ 208

Je bekijkt pagina 41 van 208

BELLECOUTURE OVERLOCK

41

ENGLISH

Box content

- BelleCouture OverLock

- Accessory kit

- Cover

- Instruction manual

Flat bed extension/Accessory box

Pull the accessory box to the left to open it and remove the accessories.

Accessory kit

The following accessories are included with the appliance:

1. Needles

2. Large screwdriver

3. Small screwdriver

4. Tweezers

5. Cleaning brush

6. Lower cutter

7. Thread unreeling discs (x4)

8. Lubricating oil container

9. Adapters (x2)

Cover

Protects the appliance from dust and dirt. After each use, remove the thread guide holder. The spool

pin, with or without thread spool, must be pushed against the machine as far as it will go. If you have

followed the previous steps, you will be able to t the cover easily.

3. OPERATION

Connecting the foot control

Insert the foot control plug into the corresponding socket on the machine. Then, plug it into the power supply.

The sewing speed is regulated by pressing the foot control. In addition, this speed can also be adjusted by means

of the regulator at the upper end of the foot control.

NOTE: if the plug does not t completely into the socket, turn the plug around. If it still won’t t, contact a qualied

electrician to install a suitable socket. Do not modify the plug.

Power switch

When this switch is in the on position, the machine and a light will turn on.

“O” = o

“I” = on

Cover

Slide the cover to the right until it locks into place. Then, pull it down. The individual threading paths are shown

in colour on the side of the machine, as well as the threading method of the overthreading loop. In addition, the

conversion procedure of the converter and the three most common stitch types are shown.

/ 208

Bekijk gratis de handleiding van Cecotec BelleCouture OverLock, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.