Handleiding
Je bekijkt pagina 8 van 17
Instruction manual C8410i
Instruction manual C8410i
14 15
Please keep this instruction manual for future reference Please keep this instruction manual for future reference
- You can check whether your cookware is suitable by carrying out
a magnet test. Move a magnet towards the base of the pan. If it is
attracted, the pan is suitable for induction.
- If you do not have a magnet:
1. Put some water in the pan you want to check.
2. If
does not ash in the display and the water is heating, the pan is suitable.
- Cookware made from the following materials is not suitable: pure stainless steel, aluminium or
copper without a magnetic base, glass, wood, porcelain, ceramic, and earthenware.
Do not use cookware with jagged edges or a curved base.
Make sure that the base of your pan is smooth, sits at against the glass, and is the same size
as the cooking zone. Use pans that have a diameter as large as the graphic of the zone selected.
Using a pan slightly wider, will mean energy is used at its maximum efciency. If you use smaller
pan efciency could be less than expected. A pan less than the minimum dimensions detailed
below could be undetected by the hob.
Always lift pans off the induction hob – do not slide them or they may scratch the glass.
PAN DIMENSIONS
The cooking zones are, up to a limit, automatically adapted to the diameter of the pan.
However the bottom of this pan must have a minimum diameter according to the corresponding
cooking zone. To obtain the best efciency of your hob, please place the pan in the centre of the
cooking zone.
Cooking zone min. pan diameter [mm] max. pan diameter [mm]
1, 2, 3, 4 140 180
USING YOUR INDUCTION HOB
TO START COOKING
Touch the ON/OFF control. After power on, the buzzer beeps once, all
displays show “ – “ or “ – – “, indicating that the induction hob has
entered the state of standby mode.
Place a suitable pan on the cooking zone that you wish to use.
Make sure the bottom of the pan and the surface of the cooking zone
are clean and dry.
Touching the heating zone selection control and a indicator next to the
key will ash.
Select a heat setting by touching the “-“ or “+” control.
- If you don’t choose a heat setting within 1 minute, the Induction hob
will automatically switch off. You will need to start again at step 1.
- You can modify the heat setting at any time during cooking.
WARNING:
The whole hob can take a maximum power of 2800W. Consequently, the hob automatically limits
the maximum output power by restricting the power level of each heating zone.
If the display ashes
alternately with the heat setting this means that:
- you have not placed a pan on the correct cooking zone or,
- the pan you’re using is not suitable for induction cooking or,
- the pan is too small/not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone. The display will
automatically turn off after 1 minute if no suitable pan is placed on it.
Bekijk gratis de handleiding van Caple C8410i, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Caple |
| Model | C8410i |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 1465 MB |
