Handleiding
Je bekijkt pagina 10 van 34
10
2.Check Point before Installation
1) Check the 4 screws (Upper 2 pieces, Lower 2 pieces) fixing Trim Kit to the Microwave Oven
whether be fastened.
2) The Front face of Door Panel and the Front Face of Trim Kit should be on even surface.
In case, the two plate surface would not be on even surface,, loosen the screws which is fixing
the Trim. Kit to the Microwave Oven and then adjust the Trim Kit surface.
※Uneven panel surface between Door and Trim Kit would cause interference of the two parts.
3) Left，Right and Lower，Upper Gap between Microwave Oven and Trim Kit should be even.
Left Gap would be a bit bigger than right Gap.
In case, any gap would not be even, loosen the screws which is fixing the Trim Kit
to the Microwave Oven and then adjust the Gap moving the Trim Kit into the right and left
or up and down.
3.Installation Procedure.
1) Mark a center line of Cabinet on the Lower Plate of Cabinet.
2) Put the Installation Template at the lower plate of Cabinet and align the center line Between
installation template andthe center line of cabinet.
3) Fix the #3 Steel Plate at the Lower Plate of Microwave Oven using 2 pieces of #6 screws as
shown in Figure#8.
4) Fix the #4 Steel Plate at the Lower Plate of Cabinet using 3 pieces of #6 screws as shown in
Figure#9
※Once Fix the Steel Plate, remove the installation template out of Cabinet.
5) Put the Microwave Oven into Cabinet and insert #3 steel plate into the rectangular hole of #4
steel plate as shown in Figure #10.
Bekijk gratis de handleiding van Candy CA38F7N20XXW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Candy |
| Model | CA38F7N20XXW |
| Categorie | Magnetron |
| Taal | Nederlands |
| Grootte | 3342 MB |
