Handleiding
Je bekijkt pagina 10 van 128
10
WARNING: Do not use the heater in small rooms where there are people who are unable to leave the room on their
own, unless constant supervision is provided.
DEVICE DESCRIPTION: Heater - look at figure 10
A. Heating hanger for towel
B. Control panel
Description of the control panel (B) - look at Figure 8
1.Power button ON/OFF. ("ON/OFF")
2.LED display
3.Timer button
4.Minus button
5. Plus button
6. "MOD" mode selection button
Description of the LED display (2) - see figure 8
AREA I: indication of operating status:
- Sun icon - power-on icon
- "R" icon - room temperature setting mode
- Icon of the letter "T" - towel rack heating mode
AREA II: temperature setting indication:
- "SET" - indicates that you are in the process of setting: the required room temperature, hanger temperature or heating
time.
- "ON" - indicates that the unit is on
- "OFF" - indicates that the device is off and goes into standby mode
AREA III: time indication - starts working when the timer button is pressed (3)
- "TIME" - indicates that you are in the process of setting the time in 24-hour format.
OPERATION
1. To turn on the unit, press the ON/OFF power button (1). To turn the unit off, press the ON/OFF power button (1)
again, in which case the word OFF will remain illuminated, indicating that the unit is in standby mode.
2. Setting the mode
Press the mode button (6) to select between room temperature mode (letter R) and towel rack mode (letter T), the
corresponding icon will be highlighted. Then configure:
2A. TOWEL RACK TEMPERATURE SETTING (T):
If T is selected, the LED display (2) shows the surface temperature of the towel rack:
By pressing the plus button (5) or the minus button (4) you can set the temperature of the hanger in the range: 40-70
degrees Celsius. The display will flash and go off after 5 seconds.
After 2 minutes of inactivity, the display (2) will only display the towel rack mode icons "ON" and "T", after which
the display will go into a half-lit state.
2B. ROOM TEMPERATURE SETTING (R):
If R is selected - the LED display (2) shows the current room temperature.
By pressing the plus button (5) or minus button (4) you can set the desired room temperature in the range: 0-37
degrees Celsius. The display will start flashing and turn off after 5 seconds.
3. Setting the time
To activate the timer, press the button (3) on the control panel (B). The timer indication will appear on the display in
area III. Press the plus button (5) or minus button (4) to set the timer from 1 hour to 24 hours. The display counts down
the time in descending order, after which the unit will turn off automatically.
4. Screen power saving mode
If no activity is performed within 2 minutes, the LED display (2) will be put into power-saving mode, all icons will go
out, and "ON" will only light up as a power indicator. Then, when any key is pressed, the LED display screen (2) will
light up again.
5. Ambient temperature detection
Bekijk gratis de handleiding van Camry CR 7827, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Camry |
| Model | CR 7827 |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 13831 MB |
