Cambium Networks cnReach N500 Handleiding (253 Pagina's)

Handleiding

/ 253

Je bekijkt pagina 57 van 253

cnReach N500 User Guide System Configuration

phn-4980_001v004 August 2019)

2-24

Device ID

Device ID is a unique number that identifies the radio on the RF network. Each radio on a network, as

defined by the network address, is required to have a unique ID in a similar way to IP addresses on an

Ethernet network. The Device ID settings allows for configuration of data paths throughout the

network and is integral to troubleshooting with the RF Ping and RF Throughput utilities.

The Device ID can range from 1 to 65534 and may be reused on different networks.

One best practice is to use the last octet of the IP address as the device id. It isn’t necessary but can be

helpful when troubleshooting and working with networks.

Link-with Device ID

For both PTP and PMP networks, the Link-with Device ID on the End Point radio must be the Device ID

of the Access Point radio that the End Point is required to communicate with.

For PTP networks only,

the Link-with Device ID should be the Device ID of the remote radio that the

radio is required to communicate with.

On a PMP network, the AP’s Link-with Device ID must be a valid number 1 to 65534 but it isn’t used and

can be set to any value. A best practice is to simply use the device ID of the AP in this case.

The Link-with Device ID can range from 1 to 65534.

/ 253

Bekijk gratis de handleiding van Cambium Networks cnReach N500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.