Cambium Networks cnReach N500 Handleiding (253 Pagina's)

Handleiding

/ 253

Je bekijkt pagina 104 van 253

cnReach N500 User Guide System Configuration

phn-4980_001v004 August 2019)

2-71

Enter the Device ID for the radio on the opposing end of the link and press Ping.

Note

When using this utility on a cnReach N500 radio, it is necessary to select which Source Radio (RF

Module) to use for the test.

Once the test is initiated the radio will attempt one “ping” at the RF protocol level. This is not the same

pings as ICMP; they are strictly at the RF level.

Each successful ping will report signal and noise information for both the local and remote radios at

opposing ends of the link.

The RF Ping Utility provides users with a diagnostic tool that can be used to:

• Verify that a remote End Point can be heard by the Access Point.

• Verify a specific End Point is connected to the Access Point and able to communicate.

• Obtain signal information at the Access Point for a specific link.

Clear can be used to remove previous test results from the page.

Radio ID is the ID of the opposing radio.

Name is the description given to the RF module of the opposing radio in Radio/Network Settings.

Signal and Noise levels are reported in dBm.

/ 253

Bekijk gratis de handleiding van Cambium Networks cnReach N500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.