Cambium Networks cnMatrix EX2028 Handleiding (320 Pagina's)

Handleiding

/ 320

Je bekijkt pagina 92 van 320

L2 Features 92

1. Enter configure terminal into the field. Press the Enterkey.

2. Enter interface gigabitethernet 0/1 into the field. Press the Enterkey.

3. Enter duplex half into the field to configure the duplexity of the interface. Press the Enterkey.

4. Enter duplex full into the field (If speed was set to 1000, the mtu value cannot be set to half). Press

the Enterkey.

5. Enter end into the field. Press the Enterkey.

6. Enter show interface gigabitethernet 0/1 into the field to display interface status and configuration

(verify if duplex has been correctly set on the selected interface). Press the Enterkey.

For more information, see Port Settings Parameters and Commands.

Managing Flow Control

Feature Overview

Flow Control is a per-port feature that detects packet congestion at its end and notifies the link partner

by sending a pause frame. By enabling flow control, both the Tx (sending of pause frames) and Rx

(receiving and obeying pause frames originating from a partner) are enabled. Flow control can be

enabled manually on a per-port basis, or by auto-negotiation with a compatible link partner.

Standards

l

IEEE 802.3x

Scaling Numbers

l

N/A

Limitations

/ 320

Bekijk gratis de handleiding van Cambium Networks cnMatrix EX2028, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.