Cambium Networks cnMatrix EX2028 Handleiding (320 Pagina's)

Handleiding

/ 320

Je bekijkt pagina 292 van 320

WISP Features 292

Configuring Cambium-Sync source (example)

1. Type the config terminal command into the terminal. Press the Enter key.

2. Type the no cn-sync source cnpulse command into the terminal to ignore the cnPulse as sync

source. Press the Enter key.

3. Type the end command into the terminal to go back to the Privileged EXEC mode. Press the Enter

key.

4. Type the show cn-sync command into the terminal to display the Cambium-Sync information.

Press the Enter key.

Similarly, type the cn-sync source cnpulse command to enable the cnPulse as sync source.

For the antenna, type [no] cn-sync source antenna for the same results.

Cambium-Sync output per-port

Cambium-Sync can be enabled or disabled on a per-port basis by the user, depending on what ports

devices that require sync signal are plugged in.

Configuring Cambium-Sync output (example)

1. Type the config terminal command into the terminal. Press the Enter key.

2. Type the interface gigabitethernet 0/3 command. Press the Enter key.

3. Type the cn-sync output command into the terminal to enable Cambium-Sync on port gi0/3. Press

the Enter key.

4. Type the end command into the terminal to go back to the Privileged EXEC mode. Press the Enter

key.

5. Type the show cn-sync command into the terminal to display the Cambium-Sync information.

Press the Enter key.

Similarly, type no cn-sync output command to disable Cambium-Sync on a certain port.

Configuring cnPulse power-on or power-off

The power on the cnPulse port is disabled by default for safety reasons since it is passive power and

always puts out 5V on the line. To power-on the cnPulse port type the following commands:

1. Type the config terminal command into the terminal. Press the Enter key.

2. Type the cn-sync cnpulse power command into the terminal to power-on the cnPulse port. Press

the Enter key.

3. Type the end command into the terminal to go back to the Privileged EXEC mode. Press the Enter

key.

4. Type the show cn-sync command into the terminal to display the Cambium-Sync information.

Press the Enter key.

Similarly, type the no cn-sync cnpulse power command to power-off the cnPulse port.

/ 320

Bekijk gratis de handleiding van Cambium Networks cnMatrix EX2028, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.