Cambium Networks cnMatrix EX2028 Handleiding (320 Pagina's)

Handleiding

/ 320

Je bekijkt pagina 172 van 320

L3 Features 172

How to Enable Routed Interfaces in CLI Interface (Example 1)

1. Type the config terminal command into the terminal.Press the Enterkey.

2. Type the interface gigabitethernet 0/1 command into theterminal to select an interface to be

configured. Press the Enterkey.

3. Type the shutdown command into the terminal to disable a physical interface. Press the Enterkey.

4. Type the no switchport command into the terminal to set the interfaceas aroutedport and to

erase all L2 interface configurations. Press the Enterkey.

5. Type the no shutdown command into the terminal to enable a physical interface. Press the

Enterkey.

6. Type the ip address 10.100.200.50 255.255.255.0 command into the terminal to set the IP address

of the configured interface. Press the Enterkey.

7. Type the end command into theterminal to go to the Privileged EXEC mode. Press the Enterkey.

8. Type the show ip interface into the terminal to display the IP interface status and configuration.

Press the Enterkey.

Note:

In case the command is used without the vid parameter the system allocates the greatest

VLAN ID available.

/ 320

Bekijk gratis de handleiding van Cambium Networks cnMatrix EX2028, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.