Cambium Networks cnMatrix EX2010-P Handleiding (320 Pagina's)

Handleiding

/ 320

Je bekijkt pagina 92 van 320

L2 Features 92

1. Enter configure terminal into the field. Press the Enterkey.

2. Enter interface gigabitethernet 0/1 into the field. Press the Enterkey.

3. Enter duplex half into the field to configure the duplexity of the interface. Press the Enterkey.

4. Enter duplex full into the field (If speed was set to 1000, the mtu value cannot be set to half). Press

the Enterkey.

5. Enter end into the field. Press the Enterkey.

6. Enter show interface gigabitethernet 0/1 into the field to display interface status and configuration

(verify if duplex has been correctly set on the selected interface). Press the Enterkey.

For more information, see Port Settings Parameters and Commands.

Managing Flow Control

Feature Overview

Flow Control is a per-port feature that detects packet congestion at its end and notifies the link partner

by sending a pause frame. By enabling flow control, both the Tx (sending of pause frames) and Rx

(receiving and obeying pause frames originating from a partner) are enabled. Flow control can be

enabled manually on a per-port basis, or by auto-negotiation with a compatible link partner.

Standards

l

IEEE 802.3x

Scaling Numbers

l

N/A

Limitations

/ 320

Bekijk gratis de handleiding van Cambium Networks cnMatrix EX2010-P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.